Setup
Setup
WARNING
Operating a Navigator tractor without an approved Exmark front mount attachment increases the possibility of operator entanglement in drive wheels or forward tip over. Entanglement or
When operating a Navigator tractor without an approved Exmark front mount attachment, observe the following:
•Keep feet and clothing away from tires.
•Limit operation to minimum required to install a different front mount attachment.
•Minimize speed and use extreme caution.
•Only operate on a flat level surface.
•Do Not operate up or down a trailer ramp.
•Avoid sudden acceleration or deceleration.
Figure 3
1. Jackshaft | 2. Drive shaft |
4.Align deck push arm tubes to tractor push arms and push deck rearward. Secure push arms with lynch pins on left and right sides of the unit (see Figure 4).
Assemble Deck to Navigator
Important: Do Not transport Navigator tractor without and approved Exmark front mount attachment.
1. Stop engine, wait for all moving parts to stop and remove key. Engage parking brake.
2. Roll the mower deck up to the Navigator tractor with the discharge tube down, making sure the deck springs are located above the drive wheel and below the console on each side.
3. Raise seat and install drive shaft onto jackshaft |
|
(see Figure 3) | Figure 4 |
1. | Slide the push arm into the deck push arm tube |
2. | Secure the push pin arm with lynch pin |
5. Align upper portion of the PTO rubber guard to the tabs on the front of the console and secure with a clevis pin and hairpin on each side (see Figure 5).
9
