Exmark PHZ19KA343 Pre-Start, Operating Instructions, PTO Engagement Switch, Engaging the PTO

Models: PHZ19KA343 PHZ19KA343CA

1 40
Download 40 pages 31.97 Kb
Page 17
Image 17
PTO Engagement Switch

Operation

Pull each lever rearward and outward to lock. Pull each lever inward and push forward to reset. Do Not tow machine.

PTO Engagement Switch

Located right of center on the console (left side of ignition switch).

Switch must be pulled out to the “ROTATE” position to engage the blades. Switch is pushed in to the “STOP” position to stop the blades.

Pre-Start

Fill fuel tanks. For best results use only clean, fresh regular grade unleaded gasoline with an octane rating of 87 or higher. Regular grade leaded gasoline may also be used; however, combustion chamber and cylinder head will require more frequent service. See Engine Owner’s Manual.

Do Not add oil to gasoline.

Do Not overfill fuel tank. Never fill the fuel tank so that the fuel level rises above a level that is 1/2 inch (13 mm) below the bottom of the filler neck to allow for fuel expansion and prevent fuel spillage.

Make sure you understand the controls, their locations, their functions, and their safety requirements.

Refer to the Maintenance section and perform all the necessary inspection and maintenance steps.

Note: It is not necessary for the operator to be in the seat to start the engine.

4.Place the throttle midway between the “SLOW” and “FAST” positions.

5.On a cold engine, push the choke lever forward into the “ON” position.

On a warm engine, leave the choke in the “OFF” position.

6.Turn ignition switch to the “START” position. Release the switch as soon as the engine starts.

Important: Do Not crank the engine continuously for more than ten seconds at a time. If the engine does not start, allow a 60 second cool-down period between starting attempts. Failure to follow these guidelines can burn out the starter motor.

7.If the choke is in the “ON” position, gradually return choke to the “OFF” position as the engine warms up.

Engaging the PTO

Pre-Start DANGER

The rotating blades under the mower deck are dangerous. Blade contact can cause serious injury or kill you.

Do Not put hands or feet under the mower or mower deck when the blades are engaged.

Operating Instructions

Open the Fuel Shut-Off Valve

The fuel shut off valve is located under the seat in the fuel line between the left fuel tank and the engine. Rotate the valve 1/4 turn counterclockwise to turn on fuel.

Starting the Engine

1.Move the motion control levers out to the neutral lock position.

2.Pull up and back on the parking brake lever to engage the parking brake.

3.Push in on the PTO switch to the “STOP” position.

Engaging the PTO DANGER

An uncovered discharge opening will allow objects to be thrown in an operator’s or bystander’s direction. Also, contact with the blade could occur. Thrown objects or blade contact can cause serious injury or death.

Never operate the mower with the discharge deflector raised, removed, or altered unless there is a grass collection system or mulch kit in place and working properly.

The PTO push-pull switch engages the cutting blades. Be sure that all persons are clear of the mower deck and discharge area before engaging PTO.

17

Page 17
Image 17
Exmark PHZ19KA343 Pre-Start, Operating Instructions, PTO Engagement Switch, Engaging the PTO, Open the Fuel Shut-Off Valve