Setup Guide
The Extron® 3G
WThese instructions provide a quick setup guide for experienced installers. Installation and service must be performed by authorized personnel only.
Extron
HD-SDI 101 Cable Equalizer
POWER | |
12V | MAX |
0.4A |
|
OUTPUT INPUT
Step 1
Turn all the equipment off and disconnect all cables.
400' RG6 Cable
Step 2
Place the unit on a convenient table top or mount it in a rack, under a desk, or on a projector mounting system. Follow the instructions kit.
Step 3
included with the appropriate mounting
POWER
12V
0.2 A MAX
Connect the external 12 VDC power supply (provided) to the
CVoltage polarity is important. Identify the negative lead by the ridges on the side (see the figure at right).
CAlways use a power supply specified by Extron for this unit. Use of an unauthorized power supply voids all regulatory compliance certification and may cause damage to the supply and the 3G
A | A |
Smooth Ridges
Step 4
Connect the cable from the
NFor SDI signals, the maximum length from the signal source to the 3G HD‑SDI 101 input is 500 feet (150 m). For
Step 5
Connect the cable from the
Troubleshooting
If problems are encountered, verify that the cables are routed and connected properly. If the problems persist, contact the Extron Service Department.
Headquarters
+800.633.9876
Inside USA / Canada Only
+1.714.491.1500 +1.714.491.1517 FAX
Extron USA - East
+800.633.9876
Inside USA / Canada Only
+1.919.863.1794 +1.919.863.1797 FAX
Extron Europe | Extron Asia | Extron Japan |
+800.3987.6673 | +800.7339.8766 | +81.3.3511.7655 |
Inside Europe Only | Inside Asia Only | +81.3.3511.7656 FAX |
+31.33.453.4040 | +65.6383.4400 |
|
+31.33.453.4050 FAX | +65.6383.4664 FAX |
|
© 2010 Extron Electronics. All rights reserved.
01 10