Extron electronic 68-1405-01 manual AVTrac Rough-In Adapter Installation Guide

AVTrac™ Rough-In Adapter Installation Guide

This adapter is designed for installation in new stud wall constructions, prior to installing the gypsum board walls (drywall).

(2)Masonry Screws

1. Determine where AVTrac will abut the wall. (See the
AVTrac Installation Guide [part number 68-1405-01] for
factors that must be considered before installation.)
Cut out a section of the wall base stud that is 4”
(10.1 cm) wide and align the front edge of the adapter
base with the front edge of the wall base stud (see the			Rough-In Adapter Base
figure at right).			(Front edge is level with
2. Mark the position of the holes in the adapter base,			wall base stud.)
			Wall Base Stud
	and drill at least two holes into the
Dry Wall	concrete 5/32” (0.4 cm) diameter and 1 1/2” (3.8 cm) deep. Secure
	the adapter to the floor with the provided masonry screws.
4.0"	3.	Cut a notch 1.5” (3.8 cm) high x 4” (10.1 cm) wide
		in the bottom edge of the drywall and place the
		drywall over the rough-in adapter with the top edge
		of the notch resting on top of the adapter’s front
	1.5"	support. Secure the drywall to the wall frame (see
		the figure at left).
Rough-In Adapter	4.	Install the AVTrac system. For complete information
Front Support		about installing the AVTrac system, consult the

AVTrac Installation Guide.

AVTrac™ Wall Trim Plate Installation Guide

The wall trim plate is a finishing plate that compensates for any overcuts to the existing gypsum wall during AVTrac intstallation.

Install the trim ring in place of, or behind, existing wall base trimmings as follows:

1. Install the AVTrac system, as described in the AVTrac Installation Guide (part number 68-1405-01).

2. Before snapping the cover track in place and covering the track with a carpet or rubber strip, place the trim plate against the wall so that it is seated on the AVTrac, covering the overcut hole in the wall.

3. Mark the position of the two holes in the trim ring on the wall and, using the screws provided, secure the trim plate to the wall.

4. Snap the cover track in place and cover the track and ramps with carpet, as described in the AVTrac Installation Guide (part number 68-1405-01). If required, trim the wall baseboard to fit snugly around the track and attach it to the wall, over the trim plate.

	Extron Electronics, USA		Extron Electronics, Europe		Extron Electronics, Asia
www.extron.com	800.633.9876	714.491.1500	+800.3987.6673	+31.33.453.4040	+800.7339.8766	+65.6383.4400
	FAX 714.491.1517		FAX +31.33.453.4050		FAX +65.6383.4664

Wall Trim Plate

Extron Electronics, Japan	68-1603-01
+81.3.3511.7655	Rev A
FAX +81.3.3511.7656	06 08