Extron electronic ADA 6 COMPONENT Video input, ADA 6 Component, Features, Installation

ADA 6 Component

The Extron ADA 6 Component is a component/HDTV (high- definition television) distribution amplifier. It is designed for use when one component/HDTV video signal must be sent to up to six output devices (11 with looping) without loss of signal quality.

Features

•Accepts and outputs component video.

•High bandwidth provides signal distribution with no loss of picture quality.

•Looping allows two amplifiers to be connected to provide up to 11 outputs.

Installation

To install the ADA 6 Component, do the following:

1. Remove power cords from the amplifier and all input and output devices.

2. If you are rack mounting the amplifier, attach it to a rack front panel (Extron part number 60-126-01) or rack shelf (Extron part number 60-030-01), and then mount the assembly in the rack.

3. Connect the input BNC connectors to the signal source, such as a high-definition television (HDTV). There are three connectors: R-Y, B-Y, and Y.

INPUT

HDTV Receiver				ADA 6 Component
				COUPLING
				AC
	R-Y	R-Y	R-Y	DC	R-Y	R-Y	R-Y
				R-Y
				AC
				DC
100- 240 V 50/60 Hz	B-Y	B-Y	B-Y	B-Y	B-Y	B-Y	B-Y
0.20A MAX				AC
				DC
	Y	Y	Y	Y	Y	Y	Y

HDTV CRT

HDTV Large Screen

Display

4. If you are looping amplifiers, choose the unit that will be #1,

and connect one set of its outputs to the input on amplifier #2.

5. Connect each output to the R-Y, B-Y, and Y connectors on its destination, such as a monitor or large screen projector.

6. Attach a BNC 75-ohm termination plug to each unused output connector.

7. Reattach power cords, and apply power to the amplifier and to all input and output devices.

Operation

The figure below shows the amplifier’s front and rear panels.

1

				ADA 6 Component
			Component/HDTV Distribution Amplifier
			COUPLING
			AC
R-Y	R-Y	R-Y	DC	R-Y	R-Y	R-Y
			R-Y
			AC
B-Y	B-Y	B-Y	DC	B-Y	B-Y	B-Y
			B-Y

100- 240 V 50/60 Hz

0.20A MAX				AC
Y	Y	Y	Y	DC	Y	Y
				Y

1 2

1Power LEDs — Light to indicate that the amplifier is on.

2AC/DC Coupling switches (3) — Normally, set to AC (up). If the application requires DC coupling, set to DC (down).

Specifications

Video

Gain	Unity
Bandwidth	180 MHz (-3dB), fully loaded

Video input

Number/signal type	1 RGsB, component video, S-video,
	composite video
Connectors	3 BNC female
Minimum/maximum levels	Analog	0.5V to 1.5V p-p with no DC
		offset at unity gain
Impedance	75 ohms
Horizontal frequency	15 kHz to 150 kHz
Vertical frequency	15 Hz to 140 Hz
Return loss	-38dB @ 5 MHz
AC/DC coupling	Yes, switch-selectable

2 ADA 6 Component ADA 6 Component 3