CS 120P • Setup Guide
| IMPORTANT: | the | ||||||
|
|
|
|
| .com | for |
| |
|
|
| .extron | installation | ||||
| to | www |
|
|
|
| . | |
Go |
| specifications | ||||||
| user |
| ||||||
|
|
| guide, |
|
|
| ||
complete | and |
|
|
|
| |||
instructions, |
|
|
|
|
|
The Extron CS 120P is a
This setup guide contains installation information about the CS 120P and provides procedures for installing it in suspended and hard ceilings.
WARNING: Incorrect installation can result in serious injury. Installation and service must be performed by authorized personnel only.
NOTES:
•All wiring and electrical connections must conform to all applicable building codes and local ordinances.
•Mounting must conform to all applicable building codes and local ordinances.
Installing the CS 120P Enclosure
The CS 120P enclosure must first be mounted in the ceiling and wired for use with the CS 26T driver assembly before the CS 26T speakers can be installed.
The minimum ceiling thickness needed to secure the speaker is 3/8 inch (0.95 cm). The maximum ceiling thickness that can be used is 1 and 9/32 inches (3.3 cm).
For
Mounting the CS 120P in a Suspended Ceiling
1.Disconnect power
2.Verify the space where the CS 120P will be installed
3.Configure the CS 120P for a U.S. or metric ceiling
Tabs (4)
Removable
Tabs
4.Remove the adjacent tile
5.Cut a hole for the CS 26T speaker. Use the provided cutout template to outline the hole to be cut in the ceiling tile as described below.
a.Remove the ceiling tile.
b. To find the center of the tile, use a tape measure to measure the space between two opposite corners, and mark the
c.Position the center hole of the cutout template directly over the center of the tile that you marked in step 5b.
1