![](/images/new-backgrounds/1000783/78333x1.webp)
Front Panel Features and Operation, cont’d
Gain and Equalization Controls
To set up your DA AV EQ, you may need to adjust the gain and equalization (EQ) for the output cable lengths. Gain and EQ are adjusted from the front panel of all DA AV EQ series products except the DA 6A and DA 3AV RCA. On
Gain and EQ potentiometers (pots) on the front panels enable
•DA 6SV EQ, DA 6SVA EQ, and DA 6SVA RCA EQ — The front panels of these models each contain one Y Gain, one Y EQ, and one C Gain potentiometer for each pair of outputs. The illustration below shows the Y Gain, EQ, and C Gain potentiometers for outputs 1 and 2.
Output Pair
1/2
you to make gain and equalization adjustments. Each pot has a white dot either above it (composite and Y gain) or to the lower left of it (EQ and C gain). These dots indicate 0 dB unity.
Use an Extron Tweeker or a small Phillips screwdriver to rotate these pots clockwise to increase gain or equalization, or counterclockwise to decrease.
Y
GAIN
0 dB Indicator Dot
Luma (Y) Gain Pot
Arrow
C
EQ GAIN
0 dB Indicator Dot
Chroma Gain Pot
Arrow
The DA AV EQ products have one EQ pot and one or two Gain pots for each pair of outputs. Therefore, gain and equalization can be adjusted only for a pair of outputs at a time. For example, if you adjust the equalization pot for output 1, output 2 is automatically adjusted at the same time and by the same amount, .
This means that you should have cables of the same length for both outputs of a pair.
•DA 6V EQ, DA 6AV EQ, DA 6AV EQ RCA,
DA 8V/4V Dual EQ, and DA 12V/6V Dual EQ — The front panels of these models feature one Gain and one EQ pot for each pair of outputs. The illustration below shows the Gain and EQ pots for outputs 1 and 2.
Output Pair
1/2
GAIN EQ
0 dB Indicator Dot
Gain Pot | Equalization (EQ) Pot |
Equalization (EQ) Pot
(for Luma [Y])
Luma and chroma Gain and EQ potentiometers for an output pair
Settings for short cables
At the factory, the DA AV EQ pots are set precisely to the unity gain position (with the arrow on the pot pointing to the dot beside or above it). If you are using very short output cables, do not turn these pots; leave them at the factory default setting. If the pots have already been turned, reset them to the default position. The illustration below shows outputs 1 and 2 set to the unity gain position.
1/2 | 1/2 |
|
GAIN EQ | Y | C |
| GAIN EQ | GAIN |
Composite Video Models |
Potentiometers for outputs 1 and 2 at unity gain settings
Arrow
Arrow
0 dB Indicator Dot
Gain and EQ potentiometers for an output pair
DA AV EQ Series • Front Panel Features and Operation | DA AV EQ Series • Front Panel Features and Operation |