Installation Notes for PMK 450 (70-618-03)
|
| Front Plate (1) | ||
The Extron PMK 450 Projector |
| Top Plate (1) | ||
| Pipe Collar (1) with | |||
Mounting Kit can accommodate |
| |||
multiple Extron products of one |
| Set Screws (4) | ||
|
| |||
eighth, quarter, or half rack sizes |
|
| ||
with power supplies. |
| AC Power Cord | ||
The components of the PMK 450 |
| Access Slot | ||
|
| |||
kit are shown in Figure 1. Also |
|
| ||
included are: |
| Plate | ||
|
|
| ||
• | Security Screws (2) | Screws (4) | ||
• Security screw hex wrench |
| |||
|
| |||
| (1) |
| Rear Plate (1) | |
• Velcro™ Pads for securing |
|
| ||
| power supply (2) |
|
| |
• |
|
| ||
| devices (6) |
|
| |
|
| Bottom Plate (1) |
| |
|
|
| Filler Plate (1) | |
Installation | Figure 1 — Contents of PMK 450 kit | |||
| Pipe Collar & | |||
CAUTION Maximum load for the PMK 450 is 15 lb (6.8 kg). | ||||
Set Screws | ||||
1. | Unscrew the front and rear plates and the security | FRONT | ||
| ||||
| screws from the sides. Slide the top and bottom |
| ||
| plates apart. The filler plate is attached to the rear |
| ||
| plate and should not be removed. |
| ||
2. | Ensure that the mounting pipe is installed with |
| ||
| the cable access hole facing the rear, away from the |
| ||
| projector screen. |
| REAR | |
3. | Loosen the four pipe collar set screws to allow the | Extron PMP | ||
| top plate to move freely along the pole. | |||
|
| |||
4. Slide the top plate up the pipe until the pipe collar is | Figure 2 — Mount top plate on pole | |||
| positioned just above the cable access hole (Figure 2). | Cable Input from | ||
| Ensure the rear of the top plate is facing to the rear, in | |||
| Sources (AV control) | |||
| the same direction as the cable access hole in the pipe. | |||
| Bottom Plate | |||
5. Level the top plate and secure it by fully tightening | ||||
FRONT | ||||
| the set screws. At least three screws must come in |
| ||
| contact with the pipe. |
|
| |
6. | Route the cables so that they exit the pipe via the |
| ||
| cable access hole (Figure 3). |
| Cable Access | |
7. | Using the supplied | |||
Hole | ||||
| to the bottom plate. Figure 3 shows the PVS 204 | REAR | ||
| screwed to the plate with a power supply attached by | Cable Output | ||
| the supplied Velcro pads. |
| ||
|
| to Projector | ||
|
|
| ||
8. | Attach cables to the device(s) and pull excess cable |
| ||
| back into the ceiling. Feed the output cables to the | Figure 3 — Route cables | ||
| projector via the cable access hole and the bottom of | |||
|
| |||
| the pipe. |
| ||
|
|
| ||
|
|
| 11 07 | |
PMK 450 Projector Mounting Kit • Installation Notes |
