Setup Guide — RGB 580xi
This guide provides basic instructions for an experienced installer to set up and operate the Extron RGB 580xi.
Installation
Refer to the RGB 580xi User’s Manual for details.
CInstallation and service must be performed by authorized personnel only.
Step 1 — Powering down
Turn off or disconnect all equipment from power sources.
Step 2 — Mounting
Mount the interface as desired.
Step 3 — Video input
Connect an RGBHV, RGBS, RGsB, or RsGsBs analog video input to the front panel
610
1 5
11 15
Pin | Description | Wire ID | Pin | Description | Wire ID |
1 | red signal | red coax | 10 | horizontal sync ground | black coax shield |
2 | green signal | green coax | 10 | vertical sync ground | yellow coax shield |
3 | blue signal | blue coax | 10 | audio ground | black wire |
4 | horizontal shift + | green wire | 10 | LED ground | yellow wire |
5 | horizontal shift — | brown wire | 10 | shift ground | grey wire |
6 | red coax ground | red coax shield | 11 | audio right | red wire |
7 | green coax ground | green coax shield | 12 | audio left | white wire |
8 | blue coax ground | blue coax shield | 13 | horizontal sync | black coax |
9 | LED red | orange wire | 14 | vertical sync | yellow coax |
|
|
| 15 | LED green | pink wire |
|
|
|
|
|
|
Step 4 — Audio input
Connect an unbalanced stereo input to the front panel 3.5 mm stereo mini jack.
Step 5 — Video output
Tip (L)
Ring (R)
Sleeve ()
Connect a display device to the rear panel video output BNC connectors, as shown below.
R | G | B | H/HV | V | R | G | B | H/HV | V | R | G | B | H/HV | V |
|
| RGBHV |
|
|
|
| RGBS |
|
| RGsB (Sync on Green) |
| |||
|
|
|
|
|
|
|
|
|
| RsGsBs (output only if input is RsGsBs) |
Step 6 — Audio output
Connect an audio device to the 3.5 mm,
Tip | L | Tip | |
NO Ground Here | |||
| Ring | ||
Sleeve(s) |
| Sleeve(s) | |
Tip | R | Tip | |
NO Ground Here | Ring | ||
|
L R
Unbalanced Audio Output
CAUTION
For unbalanced audio, connect the sleeve(s) to the ground contact.
DO NOT connect the sleeve(s) to the negative
Balanced Audio Output
Do not tin the wires!
1