Cutout Template
188 mm x 275 mm(7.4” x 10.8”)
Paint Guard
SI 26W
User’s Guide |
|
| |
|
|
|
|
1
Determine the speaker location.
Leave at least 1” clearance from the edge of the speaker
to the studs in all directions. Hold or tape template in location, make sure template is level. Trace along the inside of the template.
At least 1” from the stud.
Trace template
2
Carefully cut a hole along the inside of the traced line.
Cut material
3
Attach the speaker wires to the
SI | 26W |
Speaker | |
4
Insert the speaker into the wall opening.
Loosen the six screws on the front baffle (counter- clockwise) 1/2 turn. Then tighten the screws (clockwise) until the dog legs clamp the speaker to the wall.
5
Level speaker, position each wall clamp outward, and tighten each screw until snug.
Install dust shield to protect the speaker during ongoing construction.
CAUTION Do notDust Shield
6
Remove the dust shield, install the speaker grill.
Specifications:
Acoustic & ElectricalSpeaker type | |
Frequency range | 40 Hz to 20 kHz, |
Power capacity | 60 W continuous program, |
| 30 W continuous pink noise |
Nominal sensitivity | 89 dB, 1 W, 1 m, half space |
Nominal impedance | 8 ohms |
Application diagram:
Projector | SI 26W |
Crossover frequency | 2.5 kHz |
Woofer | 6.5" (165 mm) polypropylene cone with |
| moisture resistant coating |
Tweeter | 0.75" (19 mm) titanium dome |
Extron MLS 304SA
Temperature/humidity | Storage: |
| 10% to 90%, noncondensing |
| Operating: +32 to +122 °F (0 to +50 °C) / |
| 10% to 90%, noncondensing |
Warranty | 5 years parts and labor |
NOTE: All nominal levels are at ±10%.
NOTE: Specifications are subject to change without notice.
MediaLink Switcher
Laptop
w/ Audio
VCR | PC |
|
08 07