Extron electronic SI 26CT Suspended Ceiling Installation, Painting the Speaker Baffle, Packaging

SI 26CT

User’s Guide Ceiling Speaker

Suspended Ceiling Installation

1

Remove the ceiling tile where the speaker is to be installed.

2

Cut the hole in the tile. See step 1 of the Frame Construction Ceiling Installation section on the back.

Painting the Speaker Baffle

Cut along the smaller perforated line of the cutout template, marked as paint shield. Push it into the front baffle of the speaker. Paint the front. Remove the paint shield after the paint has dried.

3

Bring the speaker cable through the hole of the cut tile, then reinstall the tile.

4

Remove the adjacent tile. Place 2 V-rails and 1 C-ring across the tile where speaker is to be installed. Insert the speaker through the bottom of the hole in the ceiling tile.

C-ring

V-rail

5

Connect the wires to the speaker terminal clips (see step 2 on the back).

6

Loosen the four screws on the front baffle (counter clockwise) 1/2 turn. Then tighten the screws (clockwise) until the dog legs clamp the speaker to the ceiling.

CAUTION Do not over-tighten screws!

7

Connect a secondary support line from the seismic tab to a secure support point (see step 5 on the back).

8

Apply 4 pieces of black putty (supplied), equally spaced 90° apart, to the upper inside edge of the grille (see step 5 on the back).

Install the speaker grille.

Application diagram

			Extron
PC			SI 26CT
VGA w/			Two-way Ceiling
Audio Cable
			Speakers
			181T
		MPA
	C	OUTPUTS	70V
	US	COM
REMOTE

			70V
INPUTS	10V		4/8 Ohms
(MONO)	VOL/MUTER
	L	(MONO)

	R	Extron
	L
	POWER
DVD/VCR Combo	3A MAX	MPA 181T
Composite	12V
Audio RCA	Variable	Mini Power Amplifier

	MUTE 100
	VCM
	VOLUME
	Extron
Projector	VCM 100 AAP
	Volume/Mute Controller
Packaging
Mounting Screws
& Putty
	Speakers
	C-rings
V-rails (4)

Speaker Grilles