Cutout Template
224 mm x 326 mm(8.8” x 12.85”)
Paint Guard
SI 28W
User’s Guide |
|
| |
|
|
|
|
1
Determine speaker location.Leave at least 1” clearance from the edge of the speakerto the studs in all directions. Hold or tape template in location, make sure template is level. Trace along the inside of the template.
At least 1” from the stud.Trace template.2
Carefully cut a hole along the inside of the traced line.Cut material.3
Attach the speaker wires to the
Speaker type | |
Frequency range | 30 Hz to 20 kHz, |
Power capacity | 70 W continuous program, |
4
Insert the speaker into the wall opening.Loosen the six screws on the front baffle (counter clockwise) 1/2 turn. Then tighten the screws (clockwise) until the dog legs clamp the speaker to the wall.
5
Level speaker, position each wall clamp outward, and tighten each screw until snug.
Install dust shield to protect the speaker during ongoing construction.
CAUTION Do not6
Remove the dust shield, install the speaker grill.Application diagram:
Projector | SI 28W |
| 35 W continuous pink noise |
Nominal sensitivity | 89 dB SPL, 1 W, 1 m, half space |
Nominal impedance | 8 ohms |
Crossover frequency | 2.5 kHz |
Woofer | 8" (203 mm) polypropylene cone with |
| moisture resistant coating |
Tweeter | 1" (25 mm) titanium dome |
Temperature/humidity | Storage: |
| 10% to 90%, noncondensing |
| Operating: +32 to +122 °F (0 to +50 °C) / |
| 10% to 90%, noncondensing |
Warranty | 5 years parts and labor |
NOTE: All nominal levels are at ±10%.
NOTE: Specifications are subject to change without notice.
Laptop
w/ Audio
VCR | PC |
|
08 07