WARRANTY & SERVICE
This rangehood carries a limited warranty against manufac- turer's defects. To obtain warranty service, contact the dealer from whom you purchased the rangehood, or the local Faber distributor. If you cannot identify a local Faber distributor, contact Faber USA at (508)
WIRING DIAGRAM
•This rangehood uses Flourescent Lamp Type
USE AND CARE INFORMATION
This rangehood system is designed to remove smoke, cooking vapors and odors from the cooktop area.
Rangehood Control Panel
The control panel, located on the
FIGURE 9
Light On/Off Button ( L )
On/Off switch for the fluorescent light. Move the switch to "1" to turn the light ON and to "0" to turn it OFF.
Blower On/Off Button ( M )
On/Off switch for the blower. Move the switch to "1" to turn the blower ON and to "0" to turn it OFF.
Blower Speed Button ( V )
Set the blower speed control to "1" for LOW speed, "2" for MEDIUM speed and "3" for HIGH speed.
For Best Results
Start the rangehood before cooking and allow the unit to operate for several minutes after cooking is complete to clear all smoke and odors from the kitchen.
Cleaning
The metal grease filters should be cleaned frequently in hot detergent solution or washed in the dishwasher. Clean ex- terior surfaces with hot soapy water. Abrasives and scouring agents can scratch stainless steel finishes and should not be used to clean finished surfaces.
Replacing the Fluorescent Light
To replace the fluorescent light, remove the retainer clips (T) from both ends of the glass diffuser as indicated in FIGURE
10.Carefully slide the glass all the way to one end. Lower the opposite end of the glass below the support flange (L), then remove the glass by sliding it back. Replace the diffuser glass by reversing these directions.
FIGURE 10
Version 11/98 - Page 6