Fellowes 385Ci Advanced product features, Safesense Technology, Product Maintenance, Auto Oiltm

Models: 385i 385Ci

1 8
Download 8 pages 10.16 Kb
Page 4
Image 4
Models 385Ci/385i

ENGLISH

Models 385Ci/385i

Advanced product features

SAFESENSE® TECHNOLOGY

Stops shredding immediately when hands touch the paper opening.

SET-UP AND TESTING

1

2

3

4

Turn the shredder

Touch test area and

SafeSense® is active and

If hand is held on

ON ( ) to activate

look for the SafeSense®

working properly

SafeSense® area more

SafeSense®

indicator to illuminate

 

than 3 seconds shredder

 

 

 

will shut off

For more information about all of Fellowes Advanced Product Features go to www.fellowes.com/au

ENERGY SAVINGS SYSTEM

Optimal energy efficiency 100% of the time – in use and out of use.

Saves energy in four ways: energy-efficient electronics, jam prevention, standby mode and sleep mode.

Sleep Mode shuts down shredder after 2 minutes of inactivity.

WHEN IN SLEEP MODE

 

 

1

2

3

In sleep mode

To get out of sleep mode or insert paper

 

touch control panel

PRODUCT MAINTENANCE

Cleaning Auto-Start Infrared Sensors

Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the sensors may become blocked by paper dust causing the motor to run

even if there is no paper present. (Note: two paper detection sensors are located in the center of the paper entry.)

TO CLEAN THE SENSORS

 

 

 

 

1

2

3

4

5

Turn off and unplug

Lift CD flap

Locate Auto-start

Dip cotton swab in

Using cotton swab, wipe

shredder

 

infrared sensor

rubbing alcohol

away any contamination

 

 

 

 

from the paper sensors

 

 

 

 

 

Advanced product featuresSAFESENSE® TECHNOLOGYENERGY SAVINGS SYSTEMPRODUCT MAINTENANCE AUTO OILTM

Automatically oils the cutters to enhance performance and extend shredder life.

(Auto oil system is only included on cross-cut models - 385Ci)

REFILLING THE OIL

1

2

3

Low oil indicator will signal when your reservoir needs refilling

To maintain shredder

Once refilled, automatic

performance, refill oil

oiling will resume

reservoir with up to 12

 

oz. (355 ml.) of shredder

 

oil (Fellowes 35250)

 

All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and could ultimately stop running. We recommend that you refill the Auto OilTM reservoir as instructed for optimum performance.

If shipping shredder, oil must be drained. Open cabinet door and remove basket to access oil drain plug. Place suitable container under drain, remove plug and let oil drain out. Replace plug.

4

Page 4
Image 4
Fellowes 385Ci Advanced product features, Safesense Technology, Product Maintenance, Cleaning Auto-Start Infrared Sensors