SET UP
1 | 2 | 3 | 4 |
1.Ensure the machine is on a stable surface.
2.Check waste tray is empty and correctly fitted.
3.Lift the lid. Ensure the wire closing lever is pushed backwards.
4.Lift the punch handle to its upright position.
BEFORE YOU BIND
1 | 2 | 3 |
1. Select the correct wire comb | 2. Hang the selected wire | 3. Test punch scrap sheets to |
diameter using the comb | comb onto wire comb support. | check edge guide setting. |
storage tray. |
|
|
STEPS TO BIND
1
Max 15 (80gsm30 )
1.Punch sheets in small batches that do not overload the machine or user.
5
2 
3 
2. Starting with the rear cover. | 3. Punch and hang the front |
Load punched sheets directly onto | cover. Punch and hang the |
the hanging open wire comb. | remaining sheets. |
6 
7
4
4.Lift the wire comb upwards off the hooks. Carefully place into the open wire closing mechanism. Ensure the wire comb is open and touching the bottom of the mechanism.
8 
5. Lift the wire closing lever | 6. Check the closed seam. If | 7. To hide the seam, turn the |
forwards. The closing scale guide is | the seam is not closed correctly, | rear cover backwards. The front |
on the moving jaw. Close the jaws | the document can be placed | cover is now visible. The seam is |
until the wire gauge shows the size | into the jaws and closed again. | hidden inside the document. |
of wire being closed. |
|
|
8.Check wire seam closure is complete. Loose binding allows sheet loss. Good closure retains all sheets.
3
