|
| 520 |
|
| 520 CC |
| Paper shredder | 520 HS |
|
|
|
Feeding continuous forms | Electronic motor overheated |
|
–Pass the leading edge of the form under the paper guide roller (1) and into the paper feed opening (2).
2 | 1 |
8. Malfunctions
Paper jam
Red LED on keyboard lights
•Shredder reverses automatically and runs in this mode for a few seconds.
•Pull out jam and remove excess paper.
Caution!
Do not attempt to force the jammed material through the machine by alternating the cutting system between forward and reverse.
If paper jam cannot be removed
• Hold down reverse button until paper can be pulled out of the cutting system.
• Press green arrow button at least 4 sec
•Continue shredding in smaller quantities so as not to jam the machine further.
or
•Continue shredding in smaller quantities so as not to jam the machine further.
•The shredding process is started by a
Note:
The 520 HS will not run forward again unless the jammed material has been completely removed from the throat.
Red LED on keyboard lights
•Shredder switches off automatically.
•Allow shredder to cool down for approx.
– Press green arrow button at least 4 sec
Cabinet door contact ajar / bag full
Red LED lights
• Shredder switches off automatically.
• Make sure cabinet door is properly closed and/or empty waste container.
– Press green arrow button at least 4 sec
9. Maintenance
(Cross cut unit only)
–When shredding capacity drops or the noise increases.
•Spray special cutting block oil onto cutting system.
•Run cutting system forward and back- ward several times without feeding
paper.
•Continue shredding.
10.Checklist for Inoperative Machine
If the equipment does not work properly, please check the following points first:
–Is the plug inserted?
–Is the switch turned on?
–Is the cabinet door closed?
–Is the waste receptacle full? Empty waste bag.
–Is there a paper jam in the shredder? See Malfunctions
–Is the motor overheated?
Switch machine off and allow motor to cool down for approximately
If none of the above applies and the equipment still does not run, please contact our customer service department.
Edition 03/98 | 1.490.999.112 | 7 |
