Fellowes 63cb Advanced product features, Product Maintenance, Troubleshooting, Jam Blockertm

Advanced product features

Jam BlockerTM	SafeSense® Technology	Energy Savings System
Blocks jams before	Stops shredding immediately when	Optimal energy efficiency 100% of
they start	hands touch the paper opening	the time – in use and out of use

JAM BLOCKERTM

Blocks jams before they start

1 2

If Remove Paper icon ( ) is	Reduce paper quantity to
illuminated, there is too much paper	an acceptable amount and
for the shredder to power through	refeed into paper entry

If Remove Paper icon illuminates during the shredding process (due to paper misfeed or wrinkle) follow the procedures below.

1 23

Shredder pauses for	Set to Reverse (	)	Set to Auto On (	) and
3 seconds	and remove paper		refeed into paper entry

SAFESENSE® TECHNOLOGY

Stops shredding immediately when hands touch the paper opening.

SET-UP AND TESTING
1	2	3	4

Set to Auto On (	)	Touch test area and	SafeSense® is active and	If hand is held on SafeSense®
		look for the SafeSense®	working properly	area more than 3 seconds
		indicator to illuminate		shredder will shut off

ENERGY SAVINGS SYSTEM

Optimal energy efficiency 100% of the time – in use and out of use.

•Saves energy in four ways: energy-efficient electronics, jam prevention, standby mode and sleep mode.

•Sleep Mode shuts down shredder after 2 minutes of inactivity.

WHEN IN SLEEP MODE
1	2	3
	or
In sleep mode	To get out of sleep mode set to	Insert paper
	OFF ( ), then Auto On ( )

PRODUCT MAINTENANCE

OILING SHREDDER

All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin.

FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1	2	3

Set to Off ( )	*Apply oil across entry	Press and hold Reverse
		(	) 2-3 seconds

*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

Cleaning Auto-Start Infrared Sensors

Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the sensors may become blocked by paper dust causing the motor to run even if there is no paper present.

(Note: two paper detection sensors are located in the center of the paper entry).

TO CLEAN THE SENSORS
1	2	3	4

Turn off ( ) and	Locate Auto-start	Dip cotton swab in	Using cotton swab, wipe
unplug shredder	infrared sensor	rubbing alcohol	away any contamination
			from the paper sensors

Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.

TROUBLESHOOTING

Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will not. operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.

Bin Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding.

Remove Paper: When illuminated, press reverse ( ) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry.

SafeSense® Indicator: If hands are too close to the paper entry, the SafeSense® indicator will illuminate and the shredder will stop shredding. If SafeSense® is active for 3 seconds, the shredder will automatically turn off and the user must set the switch to OFF (), then Auto On ( ) to resume shredding.

3