Fellowes C-420HS manual Checklist for Inoperative Machine, Malfunctions, Maintenance, Paper jam

Models: C-420C C-420 C-420HS

1 8
Download 8 pages 39.49 Kb
Page 7
Image 7
8. Checklist for Inoperative Machine

 

420

 

420C

Paper shredder

420-2HS

 

 

8. Checklist for Inoperative Machine

If the equipment does not work properly, please check the following points first:

Is the plug inserted?

Is the switch turned on?

Is the cabinet door closed?

Is waste receptacle full? Empty waste bag.

Is there a paper jam in the shredder?

Is the motor overheated?

Switch machine off and allow motor to cool down for approximately 15–20 min.

If none of the above applies and the equipment stil does not run, please contact our customer service department.

Motor Overheating

Red LED lights

Paper shredder switches off automati- cally.

• Press rocker switch to center position

 

 

 

 

 

2

(2).

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

• Allow shredder to cool down for

 

 

 

 

 

 

approximately 15-20 minutes.

 

 

 

 

1

• Return switch to "on" position (1)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

and continue shredding.

 

 

 

 

 

 

 

 

 

 

 

 

Cabinet door ajar / bag full

Red LED lights

Paper shredder switches off automati- cally.

9. Malfunctions

Paper jam

2

3

Red LED lights

Press rocker switch to center position

(2) to stop the cutting system

Press and hold down rocker switch in pos. 3 to reverse the cutting system and back out jammed material (paper is pushed out)

 

• Press rocker switch to center position

2

(2).

 

 

• Make sure cabinet door is properly

 

closed and/or empty waste bag.

1

• Return switch to "on" position (1) and

 

continue shredding.

10. Maintenance

(Cross cut unit only)

Caution!

9. Malfunctions 1Do not attempt to force the jammed

3material through the machine by alternating the cutting system between forward and reverse

• Remove excess paper

1 • Return switch to pos. 1 and continue shredding in smaller quantities so as not to jam the machine further

Note:

The 420-2HS will not run forward again unless the jammed material has been completely removed from the throat

When shredding capacity drops or the noise increases

Apply oil over full width of cutting cylinders through the paper entry (Fellowes Powershred Lubricant

# 35250).

CAUTION: Do not use flammable synthetic oil, petroleum-based products, or aerosol lubricants of any kind.

1

Run cutting system forward and

3

 

backward several times without feeding

 

 

paper

 

Continue shredding

Edition 01/03

7

Page 7
Image 7
Fellowes C-420HS, C-420C manual Checklist for Inoperative Machine, Malfunctions, Maintenance, Paper jam