Fellowes DS-1200C Basic Shredding Operation, Troubleshooting, Oiling Shredder, Indicator lights

PAPER/CARD

1

BASIC SHREDDING OPERATION

Continuous operation: 5 minutes maximum

NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 5 minutes will trigger 30-minute cool down period.

SAFESENSE® TECHNOLOGY OPERATION

23 4

Plug in and put		alt
	Set to Auto On (I)	Feed paper/card	When finished
disconnect power		straight into paper	shredding set to
switch in ON (I) position		entry and release	OFF (O)
		alt
www.fellowes.com features an extensive on-line support section with a number of self-service options
DS-1200C	DS-1200C

SET-UP AND TESTING
1	2DS-1200C	3DS-1200C	4DS-1200C

Set to Auto On (I)	Touch test area and	SafeSense® is active and	If hand is held on SafeSense®
	look for the SafeSense®	working properly	area more than 2 seconds
	indicator to illuminate		shredder will shut off

Indicator lights:

Wait 30 minutes for motor to cool down

Yellow - SafeSense® active

TROUBLESHOOTING

DS-1200C

Paper jam: Set to Off (O) and empty bin. Replace bin and follow any or all of the below procedures.

1 2 3 4 5 6

Set to Reverse (R)	Alternate slowly back and forth	Set to Off (O)	Gently pull uncut	Set to Reverse (R)
for 2-3 seconds		and unplug	paper from paper
			entry. Plug in.

BASIC PRODUCT MAINTENANCE

OILING SHREDDER

All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin.

FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE

1 2 3

Set to Off (0)	*Apply oil across entry	Set to Reverse (R)
		2-3 seconds

*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250 Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.

LIMITED PRODUCT WARRANTY

LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to be free from defects in material and workmanship for 5 years from the date of purchase by the original consumer. Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 1 year from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED WARRANTY, INCLUDING THAT

OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law. For more details or to obtain service under this warranty, please contact us or your dealer.

2