ENGLISH

Model HD-10Cs

 

See safety instructions below

Safe Sense™ Technology (yellow)

Overheated (red)

Shredder head

Standby (green)

Paper entry

Handle

 

 

Safe Sense™ override switch

 

Grips

Bin full indicator

Control switch

Mesh basket

Auto-On ( )

 

 

Off

 

Reverse (R)

OPERATION

Continuous operation:

4-5-minute maximum

NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 4-5-minutes will trigger

20-minute cool down period.

PAPER

 

Press Auto-On ( )

Feed into paper entry

 

 

and release

Set to Off

CARD

Set to Off

Press Auto-On ( )

Feed into paper entry

 

and release

Breakthrough Safety Technology! SafeSense™ stops shredding when hands are too close to the opening.

TROUBLESHOOTING

Paper jam: Set to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or all of the below procedures.

Shredder doesn’t start:

Yellow - SafeSense™ active

Yellow flashing - SafeSense™ not active Make sure head is on basket correctly Wait 20 minutes for motor to cool down

SET-UP

Place head on basket as shown:

— To Test SafeSenseTechnology

Press and hold

Alternate slowly back and forth

Set to Off (O)

Gently pull uncut paper

Press and hold

Reverse (R)

 

and unplug

from paper entry. Plug in.

Reverse (R)

2-3 seconds

 

 

 

 

Remove and empty basket

CAPABILITIES

ATTENTION: If the SafeSense™ light remains on, you must engage the Override Switch in order to perform steps above. Once the jam is cleared, reset the SafeSense™ feature. (See SafeSense™ instructions below.)

Sensor light illuminated–paper jammed

SafeSense™ paper jam: If the SafeSense™ feature activates (SafeSense™ light remains on) to cause the user to think the shredder has jammed when it has not, use the Override Switch to deactivate the SafeSense™ feature and clear the paper. Warning – when switch is in override position, the SafeSense™ light will flash and

Will shred: Paper, small paper clips, credit cards and staples

Will not shred: Continuous forms, adhesive labels, transparencies, newspaper, cardboard, large paper clips, laminates or plastic other than

Maximum:

10*

Sheets per pass (Confetti-Cut)

Cards per pass

1

the SafeSense™ feature will NOT function. Once the paper is cleared, reset the SafeSense™ feature.

SafeSense™ override switch

noted above

Paper shred size:

 

Confetti-Cut

5/32” x 2” (3.9 x 50mm)

Passes per day

10-20

Paper width

9”/229mm

Continuous operation

4-5 minutes

*20 lb., 8.5”x11” paper at 120v, 60 Hz, 3.8Amps; heavier paper, humidity or other than rated voltage may reduce capacity.

MAINTENANCE

Run regularly in reverse for one minute

Active

Not active

Follow oiling procedure below and repeat twice.

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

Oil when bin is full, or immediately, if:

• Keep away from children and pets. Keep hands away from paper entry. Always unplug when not in use.

• Keep foreign objects – gloves, jewelry, clothing, hair, etc.– away

• Never use aerosol, petroleum-based or other flammable products on or near shredder. Do not use canned air on shredder.

• Do not use if damaged or defective. Do not open shredder head.

Capacity decreases

Motor sounds different, or Shredder stops running

Set to Off

*Apply oil

Press Auto-On ( )

Shred one sheet

Press and hold

 

across entry

 

 

Reverse (R)

 

*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250/3505006

2-3 seconds

 

 

from shredder openings. If object enters top opening, press and hold Reverse (R) to back out object.

• Avoid touching exposed blades under Confetti-Cut shredder head.

2

Do not place near or over heat or water source.

• 10 sheets per pass to avoid jams.

The socket-outlet shall be installed near the equipment and shall be easily accessible.

WARRANTY

LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to be free from

WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY

defects in material and workmanship for 3 years from the date of purchase by the original consumer.

LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall

Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 1

Fellowes be liable for any consequential or incidental damages attributable to this product.

year from the date of purchase by the original consumer. If any part is found to be defective during the

This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid

warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and

worldwide, except where different limitations, restrictions, or conditions may be required by local law.

expense, of the defective part.

For more details or to obtain service under this warranty, please contact us or your dealer.

This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED

 

3

Page 2
Image 2
Fellowes HD-10CS manual Set-Up, To Test SafeSense Technology, Capabilities, Important Safety Instructions Read Before Using