ENGLISH

Model HD-12Cs

 

SafeSense™ override switch

Shredder head

 

 

Not active

 

 

 

See safety instructions below

SafeSense™ Technology (yellow)

 

Overheated (red)

 

 

Paper entry

 

Control switch

 

 

Standby (green)

Auto-On ( I )

Off

Reverse (R)

 

OPERATION

Continuous operation:

5-minute maximum

NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 4-5- minutes will trigger

20-minute cool down period.

PAPER

 

Press Auto-On ( I )

Feed into paper entry

 

 

and release

Set to Off (O)

CARD

Set to Off

Press Auto-On ( I )

Hold credit card

Feed into center of entry

 

at edge

and release

Window

Pull-out bin

Breakthrough Safety Technology! SafeSense™ stops shredding when hands are too close to the opening.

To Test SafeSenseTechnology

Shredder comes fully assembled. Remove basket packing material and plug in.

Press Auto-On ( I )

Touch test area

Sensor lights up

TROUBLESHOOTING

Paper jam: Set to Off and empty basket. Replace basket and follow any or all of the below procedures.

Set to

Alternate slowly back and forth

Set to Off (0)

Pull uncut paper from

Set to

Reverse (R)

 

 

paper entry

Reverse (R)

Shredder doesn’t start:

Yellow - SafeSense™ active

Yellow flashing - SafeSense™ not active

Make sure control switch is in

Auto-On ( I ) position

Wait 20 minutes for red light to turn off

ATTENTION: If the SafeSense™ light remains on, you must engage the Override Switch in order to perform steps above. Once the jam is cleared, reset the SafeSense™ feature. (See SafeSense™ instructions below.)

CAPABILITIES

SafeSense™ paper jam: If the SafeSense™ feature activates (SafeSense light remains on) to cause the user to think the shredder has jammed when it has not, use theOverride Switch to deactivate the SafeSense™ feature and clear the paper. Warning – when switch is in override position, the SafeSense™ light will flash and the SafeSense™ feature

Sensor light illuminated–paper jammed

Will shred: Paper, small paper clips, credit cards and staples

Will not shred: Continuous forms, adhesive labels, transparencies, newspaper, cardboard, large paper clips, laminates or plastic other than

noted above

Maximum:

 

Sheets per pass (Confetti-Cut)

........................................................................... 12*

Cards per pass

1

Paper width

9”/229mm

will NOT function. Once the paper is cleared, reset the SafeSense™ feature. SafeSense™ override switch

Not active

Paper shred size:

 

Confetti-Cut

5/32” x 2” (3.9 x 50mm)

Continuous operation

4-5 minutes

*20 lb., 8.5”x11” paper at 120v, 60 Hz, 5.0Amps; heavier paper, humidity or other than rated voltage may reduce capacity.

MAINTENANCE

Run regularly in reverse for one minute

Follow oiling procedure below and repeat twice.

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

Oil when bin is full, or immediately, if:

Capacity decreases

Motor sounds different, or shredder stops running

Set to Off (0)

*Apply oil across entry

Press Auto-On ( I )

Shred one sheet

Set to Reverse (R)

 

 

 

 

2-3 seconds

Keep away from children and pets. Keep hands away from paper entry. Always unplug when not in use.

• Keep foreign objects – gloves, jewelry, clothing, hair, etc.

– away from shredder openings. If object enters top opening, switch to Reverse (R) to back out object.

• Avoid touching exposed blades under Confetti-Cut shredder head.

2

• Never use aerosol, petroleum based or other flammable products on or near shredder. Do not use canned air on shredder.

• Do not use if damaged or defective. Do not open shredder head. Do not place near or over heat or water source.

• 12 sheets per pass to avoid jams.

The socket-outlet shall be installed near the equipment and shall be easily accessible.

*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

WARRANTY

LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to be free from

WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY

defects in material and workmanship for 5 years from the date of purchase by the original consumer.

LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes

Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 1

be liable for any consequential or incidental damages attributable to this product.

year from the date of purchase by the original consumer. If any part is found to be defective during the

This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid

warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and

worldwide, except where different limitations, restrictions, or conditions may be required by local law.

expense, of the defective part.

For more details or to obtain service under this warranty, please contact us or your dealer.

This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED

 

3

Page 2
Image 2
Fellowes HD12CS manual To Test SafeSense Technology, Important Safety Instructions Read Before Using