Fellowes HS-1010 manual Basic SET-UP Basic Shredding Operation, Sheet Capacity Gauge, Paper JAM

BASIC SET-UP BASIC SHREDDING OPERATION

SHREDDER SET-UP

1 2

Ensure access	Make sure safety
to a dedicated	flap is securely
20Amp, 120V	in place
outlet
OILING SET-UP

PAPER

1	2	3	4	5
	R		R	or
Plug in and make	Press ( ) ON to	Feed paper	When finished	Do nothing and
sure door is closed	activate	straight into paper	shredding set to	shredder will go
		entry and release	( ) OFF	automatically to
				sleep mode after
				1 hour

1 2 3

Remove oil bottle	Hook oil	Remove lid
holder from	bottle holder	from oil bottle
cabinet	into side of
	cabinet

4	5	6	7	8
			R	R
Put oil tube into oil Place oil bottle		Close door. Plug	Oil pump starts	After changing oil
bottle and screw	into oil holder on	into socket-outlet	automatically on	bottle, press Reverse
stopper on	side if cabinet		first use. To stop Oil	(R) until Oil Indicator
			Indicator ( ) from	( ) no longer
			blinking red, press	blinks red
			ON ( ) after 15
			seconds

SHEET CAPACITY GAUGE
Eliminates frustrating jams by preventing overloads.
	Electronically measures paper thickness to prevent
	paper jams:
	Up to RED: Too many sheets have been
	inserted. Automatic reverse of paper.
	Up to YELLOW: Maximum sheet capacity.
R	Up to GREEN: Normal sheet capacity
	during shredding process.

SLEEP MODE
WHEN IN SLEEP MODE
1	2	3

R

In sleep mode	To get out of sleep or	insert paper
	press ON ( )

TROUBLESHOOTING AND PREVENTIVE MAINTENANCE

•Empty wastebasket when bin full indicator lights up.

•Shredder won’t run if the door is open, or bin needs to be emptied.

•Maintenance is an important part of protecting your investment. Don’t forget to purchase our oil (3505801) and shredder bags (3604101).

Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.

PAPER JAM

Set to Off () and empty bin. Replace bin and follow the below procedures.

1 2 3

Stops automatically	Gently pull uncut	Shred One Sheet
if too much paper	paper from
is inserted.	paper entry.
Automatic reverse	Machine runs for
if paper jams	a short time in
	reverse. Repeat if
	necessary

LIMPIEZACLEANINGDE LOSAUTOSENSORES-STARTINFRARROJOSINFAREDDESENSORSI ICIO AUTOMÁTICO

Paper detection sensors are designed for maintenance free operation. However, on rare occasions the sensors may become blocked by paper dust causing the motor to run even if there is no paper present (Note: two paper detection sensors are located in the center

of the paper entry).

TO CLEAN THE SENSORS

1234

Turn off and	Locate Auto-start	Use thin, long-handled	Clean any
unplug shredder	infared sensor	brush to clean sensors.	contamination from
		Make sure brush is	the paper sensors
		clean and dry

2