Fellowes P-12C English, Key, Capabilities, Maximum, Paper passes 10 credit cards sheets per pass

A.

E.

D.

C.

					ENGLISH
					Model P-12C
F
G.
	KEY
B.	A. Shredder head	F. Disconnect power switch	H. Control switch and LEDs
	B. Paper/credit card entry	G. See safety instructions	I	1. Auto-On
	C. Pull-out bin		O	2. OFF
	D. Window		R	3.	Reverse
H.	E. Safety lock			4.	Standby (green)
				5.	SafeSense® Technology
					(yellow)
				6.	Overheat (red)

Breakthrough Safety Technology! SafeSense® stops shredding when hands are too close to the opening.

CAPABILITIES

Will shred: Paper, small paper clips, credit cards and staples

Will not shred: Continuous forms, CD/DVDs, adhesive labels, transparencies, newspaper, cardboard, large paper clips, laminates, file folders, X-rays or plastic other than noted above

Paper shred size:
Cross-Cut	5/32 in. x 2 in. (3.9mm x 50mm)

Maximum:
Sheets per pass	..................................................................................................12*
Cards per pass	1*
Paper width	9 in. (229mm)

*8.5 in. x11 in., 20lb., (75g) paper at 120V/60 Hz, 5.0Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Recommended daily usage rates: 10-20

paper passes; 10 credit cards. 12 sheets per pass.

Fellowes SafeSense® shredders are designed to be operated in home and office environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.

IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!

•Keep away from children and pets. Keep hands away from paper entry. Always set to off or unplug when not in use.

•Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder openings. If object enters top opening, switch to Reverse (R) to back out object.

•Never use aerosol products, petroleum based lubricants or other flammable products on or near shredder. Do not use canned air on shredder.

•Do not use if damaged or defective. Do not disassemble shredder. Do not place near or over heat source or water.

•This shredder has a Disconnect Power Switch (F) that must be in the

ON (I) position to operate shredder. In case of emergency, move switch to OFF (O) position. This action will stop shredder immediately.

•Avoid touching exposed cutting blades under shredder head.

•Do not put foreign objects in paper entry.

•The grounded socket-outlet shall be installed near the equipment and shall be easily accessible.

1