GLISH |
Model |
OPERATION
Shredder head
Handle Sheet capacity icon
Paper/Card entry
See safety instructions
To set lock slide button down
Bin | Control switch | |
|
|
|
|
|
|
Continuous operation:
NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond
PAPER
| Set to | Feed into paper entry |
Set to Off (O) |
| and release |
|
| |
and plug in | CARD |
|
|
|
Set to | Hold card at edge | Feed card into center of | ||
|
|
| entry and release | |
|
|
|
|
|
Set to Off (O) and unplug
SET-UP
Safety Lock prevents accidental operation. To set, wait for shredding to stop, set control switch to Off (O) position, then slide black button down. To unlock, slide black button up. For greater safety, always unplug shredder after use.
only if the shredder head is in correct position and used with supplied basket.
TROUBLESHOOTING
Paper jam: Set to Off (O), lift head and empty bin. Replace head on bin and follow any or all of the below procedures.
Shredder doesn’t start:
Make sure switch is in auto position (I).
Make sure safety lock is in unlock position.
CAPABILITIES
Will shred: Paper, credit cards, and staples
Will not shred: Continuous forms, adhesive labels, transparencies, newspaper, cardboard, paper clips, laminates or plastic other than noted above
Maximum: | 5* |
Sheets per pass | |
Cards per pass | 1* |
Paper width | 8.75”/222mm |
Continuous operation | 3 minutes |
Set to Reverse (R) | and unplug | Gently pull uncut paper | Set to Reverse (R) |
for | from paper entry. |
| |
|
| Plug in. |
|
Make sure head is on basket correctly. Check for jam.
Remove and empty basket.
Wait 30 minutes for motor to cool down.
Paper shred size: |
|
5/32” x |
*20lb., 8.5”x11” (75g) paper at 120v, 60Hz,
Follow oiling procedure below and repeat twice.
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
• Keep away from children and pets. Keep hands away from | • Never use aerosol, petroleum based or other flammable |
paper entry. Always unplug when not in use. | products on or near shredder. Do not use canned air |
• Keep foreign objects – gloves, jewelry, clothing, hair, | on shredder. |
| |
etc. – away from shredder openings. If object enters top | • Do not use if damaged or defective. Do not open shredder |
opening, switch to Reverse (R) to back out object. | head. Do not place near or over heat or water source. |
| • 5 sheets per pass to avoid jams. |
Run regularly in reverse for one minute
Oil when bin is full, or immediately, if:
•Capacity decreases
•Motor sounds different, or Shredder stops running
WARRANTY
Set to Off (O) | *Apply oil across entry | Set to | Shred one sheet | Set to Reverse (R) |
|
|
|
| for |
*Only use a
• | Avoid touching exposed blades under | • The grounded |
• | Use only designated entry for cards. | shall be easily accessible. |
2
LIMITED WARRANTY Fellowes, Inc. (“Fellowes”) warrants the cutting blades of the machine to be free from defects in material and workmanship for 3 years from the date of purchase by the original consumer. Fellowes warrants all other parts of the machine to be free of defects in material and workmanship for 1 year from the date of purchase by the original consumer. If any part is found to be defective during the warranty period, your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling, or unauthorized repair. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential or incidental damages attributable to this product.
This warranty gives you specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations, restrictions, or conditions may be required by local law.
For more details or to obtain service under this warranty, please contact us or your dealer.
3