ENGLISH
5
If you are unable to clear the jam using this method, turn off and unplug the shredder;
remove wastebasket from the cabinet and carefully remove any paper extending below
the cutting cylinders; insert wastebasket and repeat jam clearing procedure.
Maintenance
Regular emptying of the basket
is important to ensure the smooth operation of the
cutting cylinders. If you can see paper in the basket window (7), turn off the shredder,
pull out basket and empty basket contents.
Regular oiling of the confetti-cut model (PS80C-2) is also neces-
sary to ensure proper performance. If you are running the shredder at or
near capacity, we recommend oiling it monthly. Using Fellowes Powershred
Lubricant #35250 or other non-aerosol vegetable-based oil in a long-nozzle container:
• Apply oil over full width of paper entry (1) with shredder in off (0) position.
• Press control switch (5) to automatic (I) position which will cause shredder to run for
about 2 seconds.
• Press and hold control switch (5) in reverse (R) position for 3-5 seconds.
• Repeat above automatic (I) and reverse (R) sequence three times.
REMINDER: Do not use flammable synthetic oil, petroleum-based products or aerosol
lubricants of any kind in or near the shredder at any time.
Troubleshooting
If you have a problem with your shredder, check the symptoms and remedies below. If
you cannot solve the problem this way, contact Fellowes Customer Service.
Do not open
shredder head
to attempt repair: It could expose you to serious electric shock and will
void your warranty.
Symptom
Shredder does not start or stops while
shredding.
Red display light (9) turns on and shredder
will not operate.
Shredder continues to run for a few sec-
onds after paper has cleared the cutting
cylinders.
Shredder shreds less than capacity (Model
PS80C-2 only)
Remedy
•Make sure shredder is plugged in and
switch is in automatic [I] position.
•If paper appears to be jammed. Follow
instructions under Operation.
•Check basket position; basket must be
pushed all the way in the cabinet.
Follow instructions under Set-Up.
•Wait 25 minutes for shredder to cool
down before trying again.
•If paper appears to be jammed. Follow
instructions under Operation.
•Check basket position; basket must be
pushed all the way into the cabinet.
Follow instructions under Set-Up.
No action required. This is a self-cleaning
function.
Oil the cutting cylinders. Follow the instruc-
tions under Maintenance.