Important Safety Instructions
1.Read all instructions before use.
2.Save these instructions for later use.
3.Follow all warnings and instructions marked on the product.
4.Unplug this product from the wall outlet before cleaning. Clean with a damp cloth using a mild soap and water solution. (Do not use abrasives or petroleum based cleaners.)
5.Place this product as close as possible to power source for quick and easy unplugging. Do not block the power supply receptacle; it must be possible to conveniently unplug the power cord.
6.Do not use this product near water.
7.This product should never be placed near or over a radiator or heat source.
8.Operate from the type of power source indicated on the marking label. If you are not sure of the type of power available, consult your dealer or local electricity board.
9.Do not allow anything to rest on the power cord. Do not place this product where people may walk on the cord.
10.If an extension cord is used, be sure that all products plugged into the extension cord do not exceed the extension cord ampere rating.
11.Do not attempt to service this product yourself, as opening or removing covers may expose you to dangerous live parts or other risks, and will void the warranty.
12.Unplug this product and refer servicing to qualified personnel under the following conditions:
A)When the power cord or plug is damaged or frayed.
Installation
Unpack your new shredder from its shipping container.
Place the shredder on a table top, desk or the optional shredder stand. Be sure the selected work surface is strong enough to support the weight of the shredder.
To attach the wire form feed guide, tilt the shredder back until the front feet lift off the table. Angle the wire form feed guide so one “U” curve fits around one of the metal tabs. Wrap the other side’s “U” curve around the other metal tab. Set the shredder down so the front edge of the guide extends one- half in front of the machine, with the rest of the guide between the shredder and the table.
Holding the bag support rod horizontally, pull the bag up through the center of the rod and wrap the edges of the bag over the rod. To attach the rod to the machine, squeeze the ends of the rod together enough (approximately
When shredding continuous forms, feed paper between the guide and the shredder into the shredder throat.
B)If liquid has been spilled on the product.
C)If the product has been exposed to rain.
D)If the product does not operate normally when the operating instructions are followed.
E)If the product has been dropped or the casing has been damaged.
13.Keep out of the reach of children.
14.This shredder should be operated only with an operator in attendance.
15.Do not insert aerosal cleaners into or around the shredder. Some agents may combust, causing serious injury.
Wire Form 
Feed Guide
Front Feet
Parts Identification
Front
Bag Support Rod
Back Feet
Bag
