SET UP
1 | 2 | 3 | 4 |
1.Ensure the machine is on a stable surface.
2.Check waste tray is empty and correctly fitted.
3.Lift the lid. Ensure the comb- opening lever is pushed backwards.
4.Lift the punch handle to its upright position.
BEFORE YOU BIND
1 | 2 | 3 | 4 |
1.Select the correct comb diameter using the comb storage tray.
2. Insert the plastic comb into | 3. Pull | 4. Test punch scrap sheets to check |
the mechanism. | forward to open the comb. | edge guide setting. |
STEPS TO BIND
Front
Cover
Back
Cover
1. Punch front and back covers first.
2
Max 12 (80gsm/20lbs)30
2.Punch sheets in small batches that do not overload the machine or the user.
3 | 4 |
3. Load punched sheets directly | 4. When all punched sheets are loaded |
onto the opened comb. Starting | onto the comb, push the comb lever |
with the front of the document. | backwards to close the comb and |
| remove the bound document. |
CORRECTING A BOUND DOCUMENT
Additional sheets may be included or removed at any time by opening and then closing the comb as previously described.
REMOVAL OF WASTE CLIPPINGS
The waste tray is located under the machine and is accessed from the right side. For best results empty the tray regularly.
STORAGE
Lower the punch handle to the horizontal position. Lower the lid. The Starlet comb binder is designed to be stored horizontally or vertically. There are feet that enable them to stand upright.
TROUBLESHOOTING
Problem | Cause | Solution |
|
|
|
Punched holes are not central | Edge guide not set | Adjust edge guide until hole pattern is correct |
|
|
|
Machine will not punch | Blockage | Check waste tray is empty. Check for blockage to paper entry. |
Punch holes are not parallel to edge. | Debris is stuck below dies. |
Take stiff cardboard and slide into the paper entry. Move the cardboard sideways to release any stray clippings into the waste tray.
Partial holes | Sheets not correctly aligned to punch pattern. | Adjust edge guide and test punch scrap sheets until correct |
|
|
|
Damaged hole edges | Possibly overloading the machine | Punch plastic covers with paper sheets. Reduce number of sheets being punched. |
|
|
|
Waste tray leaks | Waste tray is not correctly inserted or ‘burst feature’ has activated | Check waste tray is empty and ‘burst feature’ is closed. |
WARRANTY
Fellowes warrants all parts of the binder to be free of defects in material and workmanship for 2 years from the date of purchase by the original consumer. If any part is found to be defective during warranty period, your sale and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part. This warranty does not apply in cases of abuse, mishandling or unauthorised repair. Any implied warranty, including that of merchantability or fitness for particular purpose, is hereby limited in duration to the appropriate warranty period set
forth above. In no event shall Fellowes be liable for any consequential damages attributable to this product. This warranty gives you specific legal |
|
rights. You may have other legal rights that vary from this warranty. The duration, terms and conditions of this warranty are valid worldwide, |
|
except where different limitations, restrictions or conditions may be required by local law. For more details or to obtain services under this | 3 |
warranty, please contact Fellowes or your dealer. |
