DO NOT BLOCK FAN OPENING
|
| TYPE: PR 308 |
|
|
|
|
|
|
| OUTPUTS | PATCH POINT | BALANCED INPUTS | |
900W |
| SERIAL NUMBER | PARALLEL SPKR. JACKS | RETURN | SEND |
|
|
|
|
| |||
|
|
|
|
|
| |
|
|
| 500W |
|
|
|
| FUSE |
| 2Ω |
|
|
|
| F10A |
|
|
|
| |
|
| MIN |
|
|
| |
| 250V | CAUTION: CHASSIS SURFACE HOT |
|
|
| |
| TOTAL |
|
|
| ||
|
| WARNING: TO REDUCE THE RISK OF FIRE |
|
|
| |
ATTENTION: | CAUTION: | OR ELECTRIC SHOCK , DO NOT EXPOSE THIS |
|
|
|
|
EQUIPMENT TO RAIN OR MOISTURE | CLASS 2 WIRING |
|
|
| ||
AVIS: RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR |
|
|
| |||
UTILISER UN FUSIBLE DE | TO REDUCE THE RISK OF |
|
|
|
| |
RECHANGE DE MEME | FIRE, REPLACE FUSE WITH | ATTENTION: SUPERFICIE DE CHASSIS CHAUDE |
|
|
|
|
TYPE ET CALIBRE | SAME TYPE AND RATING |
|
|
|
|
J KL L M N O O
H. PEAK LED INDICATOR - The red Peak LED Indicator illuminates when the output voltage of the amplifier reaches clipping (maximum output voltage). The threshold for the peak indicator automatically adjusts for load impedance and supply voltage variations.
I. POWER SWITCH - The power switch turns the unit on and off. The LED (item F) is illuminated when the amplifier is turned on and main voltage is present.
REAR PANEL
J.POWER CORD - The
K.EXTERNAL FUSE - When necessary, replace the external fuse ONLY with one of the same type and rating as shown on the label next to the external fuse holder.
L.OUTPUT SPEAKER JACKS - Two
1/4"output connectors are provided capable of providing 500 Watts of power into a 2Ω minimum load total. (One 2Ω speaker or two speakers at 4Ω each).
M. PATCH POINT RETURN CONNECTOR - Provides the possibility of using the power amplifier by bypassing the preamp section of the unit. When this connector is used, the preamp is totally disconnected from the power amplifier section. If nothing is plugged into this jack, it normally takes its signal from the preamp output, via the PATCH POINT SEND jack. (See section N).
N. PATCH POINT SEND CONNECTOR - This connection can be used with the patch point return connector, if further signal processing by an external unit is desired. Processing could include the insertion of a 1/3 octave graphic equalizer for tonal shaping, an external compressor/limiter and/or the insertion of an active electronic crossover network for
O. BALANCED INPUT CONNECTORS - This unit provides two types of input connectors: a 1/4 inch TRS and an XLR female connector. The 1/4 inch TRS connector polarities are: tip (+), ring
5