Fender SR6300, SR8500

wwwwww

ffeennddeerr..ccoomm

✧

wwwwww

..mmrrggeeaarrhheeaadd..nneett

20. Effects Return level - Adjusts the amount of signal

sent to the left and right program mixes from the

effects return.

21. Effects Master level - Adjusts the amount of signal

from the built in DSP effects module to the Left,

Right and Main program mixes.

22. DFX Send level - Adjusts the master level of signal

present at the EFFECTS SEND jack from the

internal effects bus.

23. Aux In level - Adjusts the signal level from the Aux

In jack applied to the Left, Right and Main program

mixes.

24. Tape In level - Adjusts the signal level from the tape

in jack applied to the Left, Right and Main program

mixes.

25. Monitor Out level - Adjusts the overall level of

monitor signal bus to the monitor out jack.

26. System Mode Switch - This switch controls which

mixer programs are sent to the internal power

amplifiers. The options are Left and Right, Monitor

and Main, or Bridged mono mode.

27. Main Master Volume - Adjusts the overall level of

the main program mix, which is a mono sum of the

left and right channels.

28. Power LED - LED is lit when power is applied to the

mixer.

29. Phantom Power Switch - When this button is

pressed, a +48 DC Phantom Power supply is

activated and the adjacent LED illuminates.

Phantom power is necessary for some condenser

style microphones. Before plugging or unplugging

and microphone, make sure the power supply is off.

Ensure the master volume is down before turning on

the phantom power.

Master Inputs and Outputs

30. Effects Send Jack – This unbalanced, line level

output jack is designed to feed the effects bus to

an external effects processor.

31. Effects Return (L and R) Jacks – These

unbalanced, line level input jacks are meant to

accept a signal from an external effects

processor and transfer it to the left and/or right

program mixes.

32. Monitor Output Jack – This unbalanced, line level

output jack is designed to output the monitor mix to

an external power amplifier or powered monitor

such as the 1270P.

33. Aux In (L and R) – The auxiliary input jacks are

consumer line level (-10 dBm), unbalanced jacks

which provide additional inputs to the Left and Right

program mixes.

34. Tape in Jacks – The tape in jacks are RCA inputs

designed to input a stereo mix from a CD player or

tape deck to the stereo L/R busses.

35. Tape Out Jacks – The tape out jacks are RCA

outputs for use with a recording device.

36. Mix Output Jacks – These output jacks provide a

line level signal of the left and right program mixes.

AC Power and Power Amplifier

37. Speaker output Jacks – These are speaker level

output jacks designed to feed your main or monitor

speakers. The minimum impedance is 4 ohms;

connecting a load of less than 4 ohms may result in

unsatisfactory performance such as early

overheating and thermal shutdown.

38. Bridged Mono output Jack – This is a speaker

output that can be used to combine the power of

both amplifiers when more volume is needed.

Minimum impedance is 8 ohms, and only the bridge

output can be connected for proper operation.

39. Power Switch – Turns the AC power on and off.

40. AC Power Inlet – Inlet for the AC power cord.

Connect only the supplied cable to this inlet.

41. Main Fuse – This is the main fuse for the unit;

replace with a fuse of the same ratings only.

SSRR

RR66

6633

3300

0000

SSRR

RR88

8855

5500

0000