Changing tools
-Pull the unlocking ring (2.4) back and remove the tool and/or insert the new tool.
Toolholder CENTROTEC WH-CE
The CENTROTEC toolholder enables rapid changes of tools with CENTROTEC shafts.
Do not fit CENTROTEC tools at the round shaft section in a conventional chuck to prevent damage to the shaft.
Danger of injury! When changing tools, handle the tool and its sharp cutters with special care and wear protective gloves, if necessary.
Fitting
-Pull the unlocking ring (2.14) forwards, press the chuck onto the drill spindle up to the stop and release the unlocking ring.
Removal
-Pull the release ring forwards and take off the toolholder.
Changing tools
-To insert or remove a tool with CENTROTEC shaft, pull the green release ring (2.13) back. On inserting the tool, turn it until its hex shank arbour (2.12) locks in place in the hexagonal shank of the drill spindle, and push the tool into the toolholder as far as it will go.
Tool holding fixture in the drill
spindle
Bits can be fitted directly in the hexagon socket holder of the drill spindle (2.11) to make the machine lighter and shorter.
Charge battery pack
MC 15
The charger MC 15 can be used to charge all
The charge process is controlled by a micro- processor. The optimum charging current is always used depending on the temperature, voltage and internal resistance.
The LED (3.2) indicates the respective charging operation of the charger.
LED yellow - steady = Charger is ready for use.
LED green - flashing = Battery pack being charged.
LED green - fast flashing =
Battery pack being charged at max. charging current.
LED green - steady =
Battery pack fully charged, conservation charge on.
LED red - flashing =
General malfunction, e. g. incorrect polarity of battery pack, full contact not being made,
LED red - steady =
Temperature of battery pack is outside permissible limit.
If the battery pack is removed from the charging chamber during charging, charging can only be continued after
Charging with the MC 15
-Connect charger to mains. 
The line voltage and frequency must correspond with the data on the ratings plate!
-Insert battery pack with the fin (2.2) in the lower groove (3.4) of the charging chamber.
-Push battery pack into charging chamber until it catches with the lock (2.3) in the groove (3.3).
The battery pack is now charged.
Press the button (1.1) to unlock it and remove it from the charger.
Accessories, tools
The accessory and tool order number can be found in the Festool catalogue or on the Internet under
Bit depot
Attachments which are used on a regular basis, as for example the chuck key (4.2), bit extender (4.3) or different bits (4.5), can be clipped onto the bit depot (4.1).
The bit depot can be snapped into the bottom of the drill/screwdriver with its mounting lugs (4.6). When the mounting lugs are inserted into the corresponding holes (4.4) and the magazine is slid sideways the contour of the case aligns with the contour of the magazine.
The spring loaded catch of the bit magazine can loosen on impact of drill/screwdriver.
lnstructions on application -
maintenance - care
Please pay attention to the following instructions. Otherwise there is a risk of damage to the tool, charger or battery pack.
•Keep the air vents of the electronic equipment and the charger clean to guarantee the air circulation for cooling.
•Keep the connection contacts of electronic equipment, charger and battery pack clean.
•Festool chargers and Festool battery packs are designed for each other. Therefore, only use Festool chargers to charge Festool battery packs.
•By keeping the battery pack in a ready for use charger, the battery pack will be kept in
7
