Extension cord

If an extension cord is required, it must have sufficient cross-section to prevent an excessive drop in voltage or overheating. An excessive drop in voltage reduces the output and can lead to failure of the motor. The table below shows you the correct cord diameter as a function of the cord length for the RO 125 FEQ.

Use only U.L. and CSA listed extension cords. Never use two extension cords together. Instead, use one long one.

Note: The lower the AWG number, the stronger the cord.

Electronic control

The tool has full-wave electronics with ELECTRONIC the following features:

Smooth start-up

The smooth start-up ensures jolt-free startup.

Speed adjustment

You can regulate the speed steplessly between 3000 and 6000 rpm using the adjusting wheel (3.1). This lets you optimize the sanding speed to suit the material.

Constant speed

The pre-selected speed remains constant whether the tool is in operation or in neutral position.

Temperature control

To prevent overheating, the safety electronics switch the tool off when it reaches a critical motor temperature. Let the tool cool down for approx. 3-5 minutes before using it again. The tool requires less time to cool down if it is running, i.e. in neutral position.

Dust extraction

Always connect the tool to a dust extractor.

You can connect a Festool extractor with an extractor hose diameter of 27 mm to the dust extraction port (4.1).

Tool settings

Always remove the power plug from the socket before carrying out any work on the power tool.

Sanding motion

You can use the switch (5.1) to set two diffe- rent sanding motions.

The change can only be made when the sanding pad is stationary, as the switch is locked in place during operation for safety reasons.

Rotex rotary motion (coarse sanding, polishing)

The Rotex rotary motion is a combination of rotary and eccentric motions. This motion is recommended for sanding with aggressive material removal (coarse sanding) and polishing.

Slide the switch (5.1) into the right position.

Eccentric motion (fine sanding)

This motion is recommended for sanding with low material removal for a scratch- free finish (fine sanding).

Press the switch (5.1) down and push it into the left-hand position.

4

Page 4
Image 4
Festool RO 125 FEQ Extension cord, Electronic control, Smooth start-up, Speed adjustment, Constant speed, Dust extraction