First Act MA002 specifications First Act, Specifications, Facepl Ate, Backpl Ate, Output Power

FACEPL ATE

1 2 3 4 5

BACKPL ATE

6

1.INPUT JACK

Connect guitar or other instrument here (1/4” jack).

2.VOLUME

Controls output level of amplifier.

3.LED

Light indicates power on/off.

4.GAIN

Controls input level. Increasing gain adds distor- tion, or an overdriven rock tone;

decreasing gain produces a cleaner sound.

5.TONE

Turn right to add treble/reduce bass. Turn left to add bass/reduce treble.

6.POWER

Turns amplifier on/off.

INSTALLING BATTERIES

The MA002 Amplifier operates with two 9-volt alkaline batteries. Two battery compartments can be found on the back of the amp, on either side of the speaker.

Replace both batteries by following these steps:

Open the battery compartment door, pinch the tab, and pull the door to open.

To install a new battery, snap the +/- terminals of the battery into place on the connector pad.

Place the attached battery into the compartment.

Close the compartment door.

Do not mix old and new batteries. Do not mix alkaline standard (carbon-zinc) and rechargeable (nickel- cadmium) batteries.

SPECIFICATIONS

Output Power:	Input Sensitivity:
4 watts RMS	26 mV
Frequency Range:	Dimensions: (LxWxH)
60 Hz ~ 6 kHz	8" x 3.25" x 7.5"
Speaker:	Weight:
4" / 8W / 4 ohms	3 lbs.

First Act

745 Boylston Street Boston, MA 02116 USA firstact.com

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE