First Alert K5309-5V2 manual +RZWR$VVLJQ8VHU&RGHVDQG$WWULEXWHV

6HFXULW\￿&RGHV￿￿￿$XWKRULW\￿/HYHOV￿￿&RQW￿￿￿

+RZ￿WR￿$VVLJQ￿8VHU￿&RGHV￿DQG￿$WWULEXWHV￿

The following lists the various command strings for adding user codes and attributes.

Refer to the User Setup chart at the back of this manual for factory assignments of user attributes and to keep a record of user programming.

NOTE: Partition Master codes (FA168CPS only) apply only to those user numbers previously assigned (by the system master/installer) to the partition master’s partition.

Add User Code:

(Users 03/33 are preset to partition programmers, but can be changed.)

Delete User Code:

System/Partition Master code + [8] + user no. + new user’s code

User 01	= installer	User 03 = partition 1 master
User 02	= master	User 33 = partition 2 master

The Keypad beeps once to confirm that new user was added.

System/Partition Master code + [8] + [user no.] + [#] [0]

Authority Level:

Factory Assignments: users 04-32/34-49 = 0 users 03/33 = 4

Access Group:

Factory Assignments: none

User’s Partition:

(FA168CPS only) Factory Assignments: Part. 1 = users 03-32 Part. 2 = users 33-49

RF User Number:

Factory Assignments: none

Pager On/Off:

Factory Assignments: users 01-49 = 1 (on)

The user code and all attributes* programmed for this user number, including any associated RF keys, are erased from the system. (*except assigned partition)

System/Partition Master code + [8] + [user no.] + [#] [1]+ auth. level

Authority Levels (see definitions on previous page):

0	= standard user	3	= duress
1	= arm only	4	= partition master (FA168CPS only)
2	= guest

System/Partition Master Code + [8] + [user no.] + [#] [2]+ group (1-8)

You can assign users to a group, then set an access schedule that defines the times this group of users can operate the system. The system ignores these users outside the scheduled times.

System Master Code + [8] + [user no.] + [#] [3] + [0] + partition(s) + [#]

This command assigns the partitions the user can access. If more than one, enter partition numbers sequentially, then press [#] to end. E.g., master code + [8] + [user no.] + [#] [3] + [0] + [1] [2] + [#] gives the user access to partitions 1 and 2 and the common partition. Partition Entries: 1 = partition 1 and common

2 = partition 2 and common

3 = common partition only

Master/Part. Prog. Code + [8] + [user no.] + [#] [4]+ zone no.

Use this command to assign a wireless button device (keyfob) to this user (keyfob must be enrolled in system first; see installer).

Zone number: enter the zone number assigned to a button on the keyfob that will be used for arming/disarming by this user.

Master/Part. Prog. Code + [8] + [user no.] + [#] [5] + 0 or 1

You can program a user so that a message is sent to a pager whenever this code is used to arm or disarm the system. Paging On/Off: 1 = allow paging; 0 = no paging for this user

– 31 –