Setting Up Your
GENERAL PRECAUTIONS
Use only the power supply provided with the system.
Unplug the power supply when the system is not in use for extended periods.
Do not place any of the equipment near a radiator, vent, or other place where it might be exposed to heat, moisture, dust, vibrations, or strong magnetic fields. If any liquid comes into contact with the camera, turn off the power immediately and have a qualified technician inspect the equipment before using it again.
Do not attempt to repair the camera. Contact a qualified technician or the dealer for service. Any change or modification may damage the equipment and invalidate the warranty.
When installing the camera, follow manufacturer’s advice when using power tools, steps, ladders, etc. and wear suitable protective equipment (e.g., safety goggles) when drilling holes. Before drilling holes through a ceiling, check for hidden electricity cables and water pipes.
INSTALLING THE CAMERA
1Remove cover from camera lens. Select the position for the camera and secure the camera stand.
Screws and anchors are supplied. Use an appropriate screw type for the mounting surface.
2Adjust camera to the proper view angle. Make sure the lens is upright relative to your subject. Tighten the set screws.
camera lens
set screw
camera stand
3Connect the camera to power using the supplied power cable and adapter.
3
