S e ttin g Up Yo u r
P -520 Ca m e ra
GENERAL P RECAUTIONS
Use only the power supply provided with the system.
Unplug the power supply when the system is not in use for extended periods.
Do not place any of the equipment near a radiator, vent, or other place where it might be exposed to heat, moisture, dust, vibrations, or strong magnetic fields.
Do not attempt to repair the camera. Contact a qualified technician or the dealer for service. Any change or modification may damage the equipment and invalidate the warranty.
When installing the camera, follow manufacturer’s advice when using power tools, steps, ladders, etc. and wear suitable protective equipment (e.g., safety goggles) when drilling holes. Before drilling holes through a ceiling, check for hidden electricity cables and water pipes.
INSTALLING THE CAMERA
1Select the position for the camera and secure the camera stand.
Screws and anchors are supplied. Use an appropriate screw type for the mounting surface.
2
3
4
Screw the camera onto the stand. Tighten the lock nut to secure the camera on the stand.
Adjust camera to the proper view angle. Make sure the lens is upright relative to your subject. Tighten the thumb screw.
Connect the camera to power using the supplied power cable and adapter.
lock nut 
thumb screw
camera stand
The power adapter is not weather resistant and needs to be sheltered from moisture, rain, and sunlight.
3
