Fisher & Paykel CG733 installation instructions Care and cleaning, Cleaning chart

EN

26

Care and cleaning

Cleaning chart

What?		How?	Important!
Knobs	1	Clean with hot soapy water.
	2	Dry thoroughly with a soft
		cloth.

Glass surface	1	Remove the pan supports,
		burner caps, and flame
		spreaders.
	2	Remove any spills or burnt-on
		food.
	3	Apply ceramic glass cooktop
		cleaner.
	4	Wipe with a clean, damp cloth
		and dry.

Remove stains left by sugary food or spillovers as soon as possible. If left to burn on or cool, they may be difficult to remove or even permanently damage the glass surface.

Take extreme care when working around hot surfaces! Heavy-duty scourers, some nylon scourers and harsh/ abrasive cleaning agents may scratch the glass. Always read the label to check if your cleaner or scourer is suitable.

Pan supports, burner caps	1	Remove parts, then soak to
and ring		remove stubborn stains, then
		wash with hot soapy water.
	2	Rinse, then dry with a soft
		cloth.
Flame	1	Use a stiff nylon brush or a
spreaders		straightended paper clip to
		clear the holes and notches.
	2 Wash with hot soapy water.
	3	Rinse and wipe dry.

Make sure you replace the burner parts correctly, as shown in the drawings following.

Do not use the burners without all its parts correctly in place.

Dry all burner parts thoroughly before replacing as even small droplets

of water will affect the performance of a burner.

Ignitor	Use a toothbrush
	and methylated spirits
	to clean these. See
	Fig. 13.
Flame failure probe

A dirty or wet ignitor will prevent the burner from lighting efficiently.

A dirty probe may prevent the flame failure device from working effectively.