USE AND CARE

BLOWER

The motor is operated by LO/MED/HI/MAX speed control switch. You may change the speed of the motor depending on the amount of grease and smoke you are creating while cooking.

ALWAYS USE THE MAX SETTING WHEN GRILLING.

FILTERS AND DRIP TRAYS

These hoods have reusable metal grease baffles and drip trays. The metal baffles channel grease released by foods on the cooktop into the drip trays. The baffles also help prevent flaming foods on the cooktop from damaging the inside of the hood. For this reason, the baffles must ALWAYS be in place when the hood is used. The grease baffles and drip trays should be cleaned once a month, or as needed.

To clean the grease baffles and drip trays, drain and wipe all excess grease with a dry paper towel. Soak them and then swish them around in hot water and detergent. Don’t use ammonia or ammonia products because they will darken the metal. Do not use abrasives or oven cleaners. Rinse, shake and let them dry before replacing. They may also be cleaned in the dishwasher.

TO REMOVE:

Grasp the baffle knobs and pull them up, forward and out. Grasp the drip tray and carefully lift it up and out of the hood track.

To replace the drip trays:

1.Place and seat the drip tray into the hood track.

2.Slide them left or right until all trays are side-by- side in place in the track.

To replace the baffles:

1.Hold the baffle at the bottom by one of the knobs .

2.Place the other end of the baffle against the inside front of the hood.

3.Slide it up and push the bottom end back until it firmly seats into place.

To remove filters (Euro vent hood only):

1.Push handle towards the rear, then rotate the filters outwards.

2.To replace proceed in reverse order.

Fig. 02

Fig. 03

Fig. 04

7

Page 8
Image 8
Fisher & Paykel VS1236, ES36, VS36, VS30, ES30, VS48 manual USE and Care, Blower, Filters and Drip Trays, To Remove