4
Installation instructions
Preparing the rangehood for installation
Ensure the overhead cabinets are built according to Fig.5 (below).
Before drilling any holes, check that the area behind the surface to be drilled is clear of any electrical cables or pipes etc.
Recirculated installation | Knockouts (remove for ducted only) |
| If the rangehood is to be installed as a recirculated hood, |
|
| first ensure the cabinets are built according to Fig. 5 below: |
|
1 | Do not remove the knockouts shown in Fig.4. These are |
|
| removed for ducted options only. |
|
2 | Remove Cover Tape “A”. See Fig.4. |
|
| Note: for recirculation, please purchase a charcoal |
|
| filter (refer to Accessories list on page 2). |
|
3 | If an 80 mm handle is not installed (depending on model |
|
| purchased), remove front fascia “B” by undoing the 3 screws |
|
| on the fascia (see Fig. 4). | Fig.4 Preparing for install |
4 | Replace front fascia “B” with a replacement front panel “C”, | |
| constructed of same or similar material as the surrounding |
|
| cupboard doors. See Fig. 5 for height of panel. | Filtered air |
| Ducted installation | |
|
| |
| If the rangehood is to be installed as a ducted hood: |
|
1 | Remove the appropriate knockout to suit rear or top |
|
| venting, as shown in Fig.4 |
|
2 | Do not remove Cover Tape “A”. See Fig.4. This is removed | Cooking fumes |
| for recirculating only. | Fig.5 Panel heights |
|
|
Mounting the rangehood
The rangehood can be mounted in two ways, top or sides.
Before commencement, unpack the rangehood and check that it functions correctly.
Mounting to underside of cupboard
Fix the rangehood to a shelf mounted at the right height in your wall units, by drilling 4 holes, 5 mm in diameter, (see Fig.6) and fixing with the 4 screws supplied (found in the bag labelled “TOP FIXING”).
For top ducting cut hole to suit size Dimensions shown are for UNIDUCT
Drill 5 mm holes
Wall |
Cupboard
Door
Fig.6 Mounting to underside of cabinetry
