INSTALLATION INSTRUCTIONS
Fitting the water filter
1Measure out and cut the length of tube required from the filter to the refrigerator, and from the filter to the water supply. When cutting, make sure tube ends are square and clean.
2Push fit one of the tubes into the water filter (Fig. 7).
3Secure the tube to the filter by sliding a locking clip into the groove as shown (Fig. 8).
4Repeat the procedure on the other end of the filter.
5Connect the end into the plastic adaptor (Fig. 9). Screw the adaptor onto a suitable ½ BSP connector water outlet.
6Open the water valve to flush 10 L of water through the filter to remove any trapped air. Check leakage in the water tube connections.
7Access the water valve assembly at the back of the refrigerator. Push the tube into the valve assembly (Fig. 10).
Before you start using the water dispenser
Fig. 7 Filter connection
Fig. 8 Locking clip
Fig. 9 Waterline connection 
Before first use, run through and discard the first 3 L of water from the dispenser, stopping intermittently to remove trapped air in the system. Do not press for more than 1 minute to prevent overheating of the pad activator solenoid.
Fig. 10 Valve assembly
Note: there will be a delay while the tank fills until water is dispensed.
Important!
●●All connections must be checked for leaks.
●●Ensure white 6 mm tubing is routed away from sharp objects, sharp corners (beware of kinking tube as this will stop water flow), clear of the refrigerator unit compartment and not in a location where it can be squashed.
●●Ensure all
●●If tubing is removed at any point,
●●To remove tube from connection points, turn off the isolating tap, gently push the dispensing pad using a glass or container to remove static line pressure push in the collet and gently pull tubing at the same time.
13
