®
• Plug the charger into a standard wall outlet.
Note: If power flow to the wall outlet is controlled by a
switch, make sure the switch is “ON”.
• Before first-time use, charge the battery for at least 18
hours. Never charge the battery longer than 30 hours.
Note: The battery must be upright while charging.
• Recharge the battery for at least 14 hours after each use
of your vehicle.Do not charge the battery longer than 30
hours.
• Once the battery is charged, disconnect the charger
connector from the battery connector.Unplug the
charger from the wall outlet.The battery is now
ready to be installed in your vehicle.Please see the
Battery Installation section on page 16 for detailed
instructions on installing your battery.If your battery is
already installed in your vehicle, simply re-connect the
battery connector and motor harness connector, re-
assemble the pretend engine cover and lower the hood.
• If you are charging the battery for the first time, insert a
25 amp fuse into the battery.
Note: The top of the fuse will not be flush with the top of
the battery when properly installed.
• If you are recharging your battery, make sure the 25 amp
fuse already installed in the battery is in good condition.
Remove the fuse from the battery and look at it to make
sure it is not blown.Replace a blown fuse with a new
Power Wheels®25 amp fuse.
IMPORTANT
A 25 AMP FUSE MUST
BE INSTALLED IN TOP
OF BATTERY BEFORE
TOY WILL RECHARGE
OR OPERATE
®
25 Amp Fuse
13
®
Battery
Connector
Charger
Connector
2
•Squeeze the Lock-InTM connector tabs on the charger
connector and plug it into the battery connector.
IMPORTANT NOTE! If you are recharging your battery,
you will first need to remove the pretend engine cover and
disconnect the battery connector from the motor harness
connector under the hood.
•Your new battery must be charged for at least 18
hours before you use it in your vehicle for the first
time.
•We recommend that you start charging your battery
before beginning assembly of your new vehicle.
•The battery must be upright while charging.
•The charger is not a toy.
•Do not short circuit the battery.
•You do not need to remove the battery from your vehicle
to recharge it.
•Use only a Power Wheels®Type H 6 volt charger
(120 VAC 60 Hz 12W with an output of 6 VDC 800mA)
to charge your Power Wheels®6 volt battery.
9
CAUTION

Use the charger indoors only.

GOOD FUSE "BLOWN" FUSE
Battery Charging