Assembly
5 | 7 |
Metal Canopy Stay
Cover
•Tighten the screws with a Phillips screwdriver. Do not
•Repeat this procedure to attach the other ends of the frame tubes to the frame on the other side of the base.
Upper
Hole
SlotTab
6 Frame
Lower Hole
Base Wire
Lower Hole
Base Wire
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| M6 x 13/8" Screw - 4 | M6 Lock Nut - 4 | |||
|
|
|
| |||||
•Position the base wires around the base so that the ends point upward and are in front of the lower holes in a frame.
•Insert an M6 x 13/8" screw through each base wire and into the frame.
•Fit an M6 lock nut into each corresponding hexagonal opening on the back of the frame.
•Tighten the screws with a Phillips screwdriver. Do not
• Repeat this procedure to attach the other ends of the | 5 |
base wires to the frame on the other side of the base. |
|
M5 x 113/16" Screw - 2 | M5 Lock Nut - 2 |
•Position one end of the metal canopy stay against the upper hole in a frame.
•Insert an M5 x 113/16" screw through the hole in the cover.
•Fit the end of the screw through the hole in the metal canopy stay and into the hole in the frame.
•Push on the cover to insert and “snap” the tab on the cover into the slot in the frame. Make sure you hear a “snap”.
•Fit an M5 lock nut into the corresponding hexagonal opening on the back of the frame.
•Tighten the screw with a Phillips screwdriver. Do not
•Repeat this procedure to attach the other end of the metal canopy stay and the remaining cover to the frame on the other side of the base.
