Battery Installation
Hint: We recommend using alkaline batteries for longer battery life.
Assembly
IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. DO NOT use if any parts are missing or broken. Contact Mattel for replacement parts and instructions if needed. Never substitute parts.
1,5V x 4
“D” (LR20)
Base Tubes
Lift
Lift
1 Base
• Lift both base tubes.
• Loosen the screws in the battery compartment door and remove | Hubs |
the battery compartment door. |
|
•Insert four “D” (LR20) alkaline batteries into the battery compartment.
•Replace the battery compartment door and tighten the screws.
•Low battery power may cause this product to operate erratically
(no movement/no sounds) and the product may not turn off. If this should happen, remove and discard all batteries and replace with four, new “D” (LR20) alkaline batteries.
Protect the environment by not disposing of this product with
Base Tubes
household waste (2002/96/EC). Check your local authority forBase Tubes recycling advice and facilities (Europe only).
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product.
To avoid battery leakage:
•Do not mix old and new batteries or batteries of different types: alkaline, standard
•Insert batteries as indicated inside the battery compartment.
•Remove batteries during long periods of
•Never
•Use only batteries of the same or equivalent type as recommended.
•Do not charge
•Remove rechargeable batteries from the product before charging.
•If removeable, rechargeable batteries are used, they are only to be charged under adult supervision.
2
•Position the hubs with the smooth side out.
•Fit the hubs onto the base tubes.
Hint: The hubs are designed to fit the base tubes one way. If the hubs do not fit on the base tubes, check to be sure the smooth side is out.
•Push the hubs down until you hear a “click”.
•Pull up on the hubs to be sure each is secure.
3
