Assembled Parts
CAUTION
This package contains small parts in its
unassembled state. Adult assembly is required. Take extra care during unpacking and assembly.
Assembly
Support Bar | Seat |
Frame
Back Brace
Frame Assembly
Front Brace
Tray
Frame
Front Brace | Back Brace |
Support Bar
TraySeat
2 Frames
M3.5 x 15mm Screw - 8 | M4.5 x 18mm |
| Washer Head Screw - 4 |
Both Shown Actual Size
Note: Tighten and loosen all screws with a Phillips screwdriver. Do not
1
• Fit the front brace onto one of the frames.
Hint: The front brace will only fit on the frame one way. If it does not seem to fit, turn it around and try again!
•Insert two M3.5 x 15mm screws into the holes in the frame and tighten.
BACK VIEW
61
•Turn the seat face down. Insert two M3.5 x 15mm screws into the seat and tighten.
2
• Fit the back brace onto the same frame.
Hint: The back brace will only fit on the frame one way. If it does not seem to fit, turn it around and try again!
•Insert an M3.5 x 15mm screw into the hole in the frame and tighten.
Seat
Frame
Assembly
71
•Fit the seat onto the frame assembly. Push down on the seat to fit in place.
31
•Fit the other frame onto the braces.
•Insert three M3.5 x 15mm screws into the holes in the frame and tighten.
BOTTOM VIEW
81
•While holding the seat in place, turn the assembly face down.
•Insert two M4.5 x 18mm washer head screws into the holes in the back of the seat, as shown.
•Tighten the screws.
4
IMPORTANT! This step must be completed before attaching the seat to the frame assembly.
•"Snap" the support bar onto the pegs on the top of the frame assembly.
91
•Insert two M4.5 x 18mm washer head screws into the holes on the bottom of the seat, as shown.
•Tighten the screws.
51
• "Snap" the tray handles into the holes in the seat.
101
• "Snap" the bear toy into the slot in the seat.
