Assembly, Arch Base, Treetop Tree Trunk

Assembly

•Lift the arch on the base and “Snap” it into the base.

Note: The arch is connected to the base by an electrical wire. Make sure this wire retracts into the arch before snapping into the base.

•“Snap” the treetop to the tree trunk and then into base.

Note: The treetop only fits onto the tree trunk one way. If it does not seem to fit, turn it around and try again.

• “Snap” the tree trunk into the base.

Hedges	Tree Branch

3	4
1	1

•“Snap” the hedges into the slots in the base.

Note: If a hedge does not seem to fit into a slot, try the other slot.

•Insert the tree branch into the arch and the base.

•Push down on the tree branch to “snap” it in place.