Assembly
Seat Back Tube
3
• Insert screw into each foot and tighten.
Footrest 
5
Base Wires
4
•Position the footrest so that the soothing unit is upright.
•Fit the footrest onto the ends of the base wires.
•Fit the seat back tube onto the ends of the base wire.
•Push the seat back tube to be sure it is completely on the base wires.
Retainer Socket Up
6
•Fit a retainer to the outside of the seat back tube, as shown. Make sure the socket in the retainer is upright.
•Insert a screw through the hole in the seat back tube, base wire and into the inside of the retainer.
•Repeat this procedure to assemble the other retainer to the other side of the seat back tube.
•Pull the seat back tube up to be sure it is secure. If you can remove either end of the seat back tube, you have not assembled the retainers correctly. Remove the screws,
4Assembly steps 5 and 6.
