Fisher VCC-4324 manual SETTINGS

SETTINGS

C-BW			L-L		WB EI			VR301
	H				A			LEVEL
						ON
	L					OFF		L	H
						ON
			INT					DC
		SYNC			M			VIDEO
							BLC
				R	B
				VR303 VR302				A. I.
								LENS

Line phase adjustment CAUTION:

When using a camera switcher to connect 2 cameras or more to one monitor, there may be a vertical roll of the images when switched. In such a case, set as described below.

1Set the SYNC switch to the L-Lposition.

2 Switch the display on the monitor from camera 1 to camera 2.

Adjust the LINE PHASE volume on camera 2 until the vertical roll

of the image stops.

If more than two cameras are used, please repeat this procedure

If the vertical roll cannot be corrected by setting the LINE PHASE volume on camera 2, try setting the LINE PHASE volume on camera

1.If it still cannot be corrected, please check that the polarity of the power cords of all connected devices is correct.

White balance adjustment

Normally the WB (white balance) switch is set to the A (automatic) position and the white

balance is adjusted automatically. If a manualWB

for all the cameras.

white balance adjustment is necessary, follow the steps below.

A

L-L

INT

SYNC

Set the WB switch to the M (manual) position,
then adjust the color.
			M
• Turn R (VR303) to set the red ratio and/or
	R		B
B (VR302) to set the blue ratio.	VR303	VR302

English 11