Fisher VMC-8613, VMC-8618 Note:, Note:, ON”, and then press the ENTER button, 3Use the cursor l (j) button to select “TITLE, 1Select “9. TITLE ON” and then press the ENTER button

ADJUST THE OSD MENU ITEM

Displaying characters such as for setting location on the monitor screen (Refer to “CHARACTERS TABLE”.)

Note: If there is no signal being input from the input terminals selected (A, B or Y/C) at the rear of the monitor, the title cannot be set for those terminals.

1Select “9. TITLE ON” and then press the ENTER button.2To display “ABCD” on the CH B monitor as an example:

A maximum of eight characters can be displayed on the screen.

Note: The setting screen will disappear after approximately 13 seconds of no activity.

1. Use the cursor (l) button to select “CH B”.

2.Press the ENTER button, and then use the cursor l (j) button to select “A”.

3.Press the ENTER button, and then use the cursor l (j) button to select “B”.

4.Press the ENTER button, and then use the cursor l (j) button to select “C”.

5.Press the ENTER button, and then use the cursor l (j) button to select “D”.

6.Press the OSD button.

The cursor will move to the next monitor display. The settings for the CH A and CH Y/C monitors can be carried out by the same procedure as described above.

3Use the cursor l (j) button to select “TITLEON”, and then press the ENTER button.

The text that has been set for that monitor screen

will then be displayed.3 14 2l52.113 822 23226 c Rc98744