Assembly
Tank Stand (MT-200 series only)
1.Insert tank support strap into openings in tank stand as shown. See Figure A.
2.On the underside of the tank stand, loosen the two hex nuts located on the screws which extend from the sides of the base plate. Place the slots at the ends of the tank support strap over the screws and secure by tightening the two nuts. See Figure B.
PowerTrap (MT-200 & MT-300 series)
Tank Support | Tank Stand |
Strap |
Openings
Figure A
Base Plate Tank Strap
Screw & Nut
(2 places)
Figure B
Connect Propane Regulator
1 . Remove the plastic dust cover from your propane tank valve.
2 . Screw the propane regulator coupling located on the end of the propane hose onto the tank valve by turning the black threaded coupling clockwise until tight. Hand tighten only. See Illustration 4.
Note: Gas will not flow unless connection is tight.
Tighten by hand only. Using a wrench or other tool could damage the regulator coupling and could cause a gas leak.
Illustration. 4
WARNING
Check for gas leaks by wetting the connec- tions with a solution of soap and water and
1.Insert one end of the post into the post opening at the front of the tank stand. Insert opposite end of post into the post opening located at the bottom of the Flowtron Mosquito PowerTrap®. Align unit in relation to the tank stand.
See Illustration 2.
Place a 20 lb. tank on the tank stand and install tank wrap around the tank.
2.Install catch tray by first inserting the rear of the tray into the housing.
Then push in upper part of the latch and raise front of catch tray into place.S e e
Illustration 3.
Tank
Cap
Tank
Strap
Post 
Tank Stand
watching for bubbles. If bubbles form or if a bubble grows larger, there is a leak and connection must be tightened.
WARNING
Check for gas leaks every time you disconnect and reconnect a gas fitting.
Be sure there are no sparks or open flame in the area when you check for leaks.
Do not use a liquid propane tank with a damaged valve. Have dented or rusty propane tanks checked by your propane supplier.
Only use regulator supplied with your Flowtron PowerTrap.
3.Place tank cap on top of tank.
4 . ( M |
Move your unit to the |
3 . Position and screw power
pack to either an outside or inside wall adjacent to
a electrical outlet (screws not provided). Run the low
voltage wire either above or below ground from the power pack to the unit. plug the low voltage wire into the power cord connector located at the bottom of the Flowtron Mosquito PowerTrap®. Plug the power pack into the electrical outlet.
desired location in your |
yard. Remove catch tray |
and grasp housing as |
shown . |
See trap “Placement” |
instructions on pg. 4. |
Page 5
