Introduction
The SigmaPace™ 1000 External Pacemaker Analyzer (the Analyzer), is the latest in external pacemaker analyzer technology. This efficient, handheld Analyzer satisfies a wide range of external pacemaker testing.
Table
| Table 1. Symbols |
|
|
Symbol | Description |
|
|
| Important information; refer to manual. |
|
|
| Hazardous voltage |
|
|
| Do not dispose of this product as unsorted |
| municipal waste. Go to Fluke’s website for |
| recycling information. |
|
|
| Conforms to relevant Australian EMC |
| requirements |
| Conforms to relevant Canadian and US |
| standards |
|
|
| Conforms to European Union directives |
|
|
| IEC Measurement Category I – CAT I |
| equipment designed to protect against |
CAT I | transients in equipment on circuits not |
| directly connected to MAINS. Under no |
| circumstances should the terminals of the |
| Analyzer be connected to any MAINS |
| voltage. |
|
|
Warnings and Cautions
A Warning identifies hazardous conditions and actions that could cause bodily harm or death.
A Caution identifies conditions and actions that could damage the Analyzer, the equipment under test, or cause permanent loss of data.
SigmaPace 1000
Safety Sheet
External Pacemaker Analyzer
Warning
To avoid possible electrical shock or personal injury, follow these guidelines:
•Use this product only in the manner specified by the manufacturer, or the protection provided may be impaired.
•Read the Operators Manual before operating the Product.
•Do not use the product if it operates abnormally.
•Do not use the product around explosive gas, vapor, or in damp or wet environments.
•Use extreme caution when working with voltages above 30 volts.
•Use the proper terminals, functions and ranges for the test being performed.
•Do not connect the Analyzer to a patient or equipment connected to a patient. The Analyzzer is intended for equipment evaluation only and should never be used in diagnostics, treatment or in any other capacity where the Analyzer would come in contact with a patient.
Power Supply
Make sure the external battery charger / power supply is rated and configured for your voltage source, and compatible with the voltage and current ratings of the Analyzer. Use only the specified power supply included with this instrument.
July 2010 ©2010 Fluke Corporation. All rights reserved. Printed in USA. | 1 |
