Fluke FLK-TI-SBP3 instruction sheet Safety Information, Charging the Battery, Specifications

FLK-TI-SBC3

Charging Base/Power Supply with Adapters

Instruction Sheet

The Fluke FLK-TI-SBC3 Charging Base/Power Supply with Adapters charges the Fluke FLK-TI-SBP3 Smart Battery Pack for Thermal Imagers. The FLK-TI-SBC3 consists of a charging base, power supply, and power outlet adapters.

	Y
	TTER
	BA 3
	CHARGER
	RT
	SMA
SBC3
Ti

POWER

PN 3481481 August 2009

Safety Information

Use the FLK-TI-SBC3 only as specified in this instruction sheet or other Fluke product‑specific manual. See Table 1 for a list of symbols used on the FLK-TI-SBC3.

A Warning identifies hazardous conditions and actions that could cause bodily harm or death.

A Caution identifies conditions and actions that could damage the Imager or cause permanent loss of data.

WWarning

To avoid injury:

●●	Do not disassemble or short circuit the battery pack.
●●	Do not expose the battery pack to temperatures above 50 °C (122 °F).
●●	Do not incinerate or mutilate the battery pack.
●●	Use only ac adapters approved by Fluke for the product to charge the battery or
	power the product.
		Table 1. Symbols
	Symbol	Description
	P	Conforms to requirements of European Union and European Free Trade Association.
	"	Imager connected to battery charger.
	;	Conforms to relevant Australian standards.
	)	Conforms to relevant Canadian and US standards
	W	Important information. See manual.
	~	Do not dispose of this product as unsorted municipal waste. Go to Fluke’s website for
		recycling information.

Charging the Battery

Before using the battery pack for the first time, charge the battery in the two-bay charging base for at least two and one-half hours. For complete charging instructions, see the “Ti32, TiR32 Thermal Imagers User Manual.”

Specifications

See Table 2 for the specifications.

Table 2. Specifications

Battery Charging	10-15 Vdc 2 A or charge battery pack in Imager with included ac
	adapter rated: 100-240 Vac 50/60 Hz, 15 V 2 A.
	Status	Charging LED	Power LED
	off	no battery detected	no dc power input
Charging / Power LED
	solid green	charged	dc power present
	blinking green	charging	na
	blinking red	fault	na
Dimensions	159.5 mm x 68.9 mm x 51.3 mm (6.28 in x 2.71 in x 2.02 in)
Operating Temperature	-10 °C to 70 °C (-14 °F to 158 °F)
Storage Temperature	-20 °C to 80 °C (-4 °F to 176 °F) without batteries
Humidity Range	10 % to 95 % non-condensing

© 2009 Fluke Corporation. All rights reserved. Printed in USA.

All product names are trademarks of their respective companies. Specifications are subject to change without notice.